A c c e s s o r i e s
S t e m D e f l e c t o r
The stem deflector is a very simple alternative to the standard stem collector and allows access in restricted areas. To replace the
stem collector with the stem deflector proceed as follows:
P r e p a r i n g t h e B a s e To o l f o r u s e w i t h S t e m D e f l e c t o r
The airline must be disconnected before any
servicing or dismantling.
'Sealed' Nut 71213-02200 replaces Locknut
3 (to cut-off air supply to vacuum system) as
follows:
•
Loosen Locknut 3 using 16mm AF spanner.
•
Unscrew and remove Both 'T' Adaptor 1
and Locknut 3.
•
Replace Locknut 3 with 'Sealed" Nut
71213-02200, screw the 'Sealed" Nut
onto head Piston 27 to disable the
vacuum system.
•
'T' Adaptor 1 must be tightened onto
Head Piston 27 to trap Vacuum Sleeve
43 against the head piston, finally
tightening the 'Sealed' Nut against it.
STEM DEFLECTOR
07340-00342
ADAPTOR
71213-20103
STEM DEFLECTOR: 71213-20100
71401 Tool
•
Fit Stem Deflector (07340-00342) into Adaptor (71213-20103).
•
Screw Adaptor onto End Cap Assembly 71213-05103.
•
Rotate the stem deflector until the aperture faces away from the
operator and any other person(s) in the vicinity.
E x t e n s i o n
Fitted between the tool and the nose assembly the extension
allows access into deep channels.
The tool must be fitted with Jaw Spreader Housing 9*and 'O' Ring
10* before the extension can be fitted. See page 11 for fitting
instructions.
•
To fit the extension, remove any nose assembly components.
•
Screw the inner extension to Jaw Spreader Housing 9*.
•
Screw the outer onto Head Assembly 4.
•
Fit the nose assembly onto the extension.
S w i v e l H e a d s
Instead of a nose assembly, a swivel head can be fitted to a base tool. It allows 360° rotation of the tool about the nose tip and
allows access into many applications otherwise too restrictive. There are two types of swivel heads: the straight swivel head with
the nose tip slightly offset from the centre line of the tool head and the right-angle swivel head with the nose tip on a perpendicular
axis to the head of the tool. See drawings below and page 14 for dimensions and page 15 for details.
Item numbers in bold refer to the General Assembly drawing and Parts List on pages 24 and 25.
9* and 10* refers to the nose assembly components in Nose Tip tables on page 12.
SEALED NUT
71213-02200
•
•
•
STEM DEFLECTOR
07340-00342
ADAPTOR NUT
71210-20101
STEM DEFLECTOR
71404 Tool
Fit Stem Deflector (07340-00342) into Adaptor (71210-
20101).
Screw Adaptor onto End Cap Assembly 71403-02102.
Rotate the stem deflector until the aperture faces away from
the operator and any other person(s) in the vicinity.
INNER
EXTENSION - 'T' ADAPTOR 71213-12000
EXTENSION - NON QUICK RELEASE 71210-20300
71213-20103
or
71210-20101
ADAPTOR
07340-00342
STEM DEFLECTOR
SEALED NUT
71213-02200
OUTER
13