Daspi FUEGO Manual De Instrucciones página 19

UP-DOWN / SEQUENTIAL SWITCH
Press LEARN button, until it beeps
4 times, this means up/down
option is on. When the button is
released,it
change to sequential switch and
viceversa.
One shortbeepwill indicatethe
up/down selection and a longer
beep will indicate sequential
switch selection.
Thisoption can ONLY be done
withthetransmitter
OPTION 5 –MEMORY ERASING
Press LEARN button until it beeps 5 times. Thisindicatesthe erasing
mode is activated. When releasing the button all channels and
remotes will be erased.
*Note: once the memory has been deleted, it is MANDATORY to
repeat option 1 and 2 for the correct functioning of the control board.
REMOTE PROGRAMMING
Select option 1 from the MENU (Press LEARN button until it beeps one time, this
means it is on remote memorization mode).
Press the button of the remoteyou want to use, 3 beeps will confirm it has been
correctly memorized.
Control board exits automatically the memorization mode after four seconds or
after pressing again LEARN button or the already programmed remote's
button. The exit will be indicated by 3beeps.
MANEUVERS TIME PROGRAMMING
Before programming, check the correct instalation of the limit switches (in case
they are installed). The door must be closed.
The orders are given by pressing LEARN button or an already programmed
remote.
DS152B SHUTTER 2.0
will automatically
STEP BY STEP/INVERSION TO
CLOSURE
Press LEARN button until it beeps 4
times. This means inversion to
closure option
selected.When
button, menu changes to inversion
to closure and viceversa.
One shortbeep means step by step
selection and a longer beep means
inversion to closure.
19
has been
releasing the