ventyly OXYGEN Instrucciones De Montaje página 9

Tabla de contenido

Publicidad

Assembly
Snap the basically assembled fan into the
7
installed Bracket.
Click!
buckle
Step 3 (Receiver installation and wiring)
Connect the wires according to the polarity (the color of the
Install the fan in the bracket,
House power cord may be different if the color is the same).
Instala el soporte del ventilador,
Installez le support du ventilateur.
AC IN L(Brown)
AC IN N(Blue)
Ground(Yellow/green)
Put the receiver into the
9
Bracket and arrange the wires
L For light(Red)
N Neutral(Blue)
Adjust the position of Canopy,
then lock it
Step 4
Step 4
(Blades and
Place the receiver in the holder,
Align the blades with the mounting holes,
Coloca el receptor en el soporte,
and then fix them with screws.
Placez le récepteur dans le support.
11
Installation of light cover
Assemble the blades.
Ensamblar las palas.
Assemblez les lames.
OFF
House power
FAN
House power
To Motor
U(Pink)
FAN
V(Gray)
W(Red)
FAN
Assembly Instructions
Assembly Instructions
(Blades and
Light kit installation)
Light kit installation)
Align the blades with the mounting holes,
and then fix them with screws.
.3.
Installation of light cover
Click!
buckle
or
Montaje
Step 3 (Receiver installation and wiring)
Connect the wires according to the polarity (the color of the
8
House power cord may be different if the color is the same).
AC IN L(Brown)
AC IN N(Blue)
Ground(Yellow/green)
L For light(Red)
N Neutral(Blue)
Put the receiver into the
Make the connections. If in doubt, consult a technician
Bracket and arrange the wires
Haz las conexiones. Si tienes dudas consulta a un técnico.
Faites les connexions. En cas de doute, consultez un technicien.
10
Adjust the position of Canopy,
then lock it
.3.
Tighten the screws.
Remove the pre-installed screws.
Apriete los tornillos.
Connect the light kit cable, and then lock
Serrez les vis.
the light kit.
12
Assemble the light kit.
Ensamblar el kit de luz.
Assemblez le kit d'éclairage.
Montage
Solid wood roof
FAN
Not included
Screw
House power
Put the receiver into the
Bracket and arrange the wire
To Motor
U(Pink)
FAN
V(Gray)
W(Red)
Adjust the position of Canopy
then lock it
Remove the pre-installed screws.
Connect the light kit cable, and then lock
the light kit.
Insert
Put t
Brac
Adju
then
.3.
Insert

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vt23201Oxygen vt23201

Tabla de contenido