VALBERG 3S58 F WAD929C Instrucciones De Uso página 34

C
Practical information
Problem
• Stained tub interior
• White film on inside
surface
• There are rust stains on
cutlery
• Knocking noise in the
dishwasher
• Rattling noise in the
dishwasher
• Knocking noise in the
water pipes
• The dishes are not clean
Possible Causes
• Detergent with colourant may
have been used.
• Hard water minerals.
• The affected items resistant.
• A programme was not run after
dishwasher salt was added.
Traces of salt have gotten into
the wash cycle.
• The lid of the softer is loose.
• A spray arm is knocking against
an item in a basket
• Items of crockery are loose in
the dishwasher.
• This may be caused by on-site
installation or the cross-section
of the piping.
• The dishes were not loaded
correctly.
• The programme was not
powerful enough.
• Not enough detergent was
dispensed.
• Items are blocking the
movement of the spray arms.
• The filter combination is not
clean or is not correctly fitted in
the base of washcabinet. This
may cause the spray arm jets to
get blocked.
32
• Make sure that the detergent has
no colourant.
• To clean the interior, use a
damp sponge with dishwasher
detergent and wear rubber
gloves. Never use any other
cleaner than dishwasher
detergent otherwise, it may
cause foaming or suds.
• Avoid washing items that are
not corrosion resistant in the
dishwasher
• Always run a wash programme
without any crockery after adding
salt.
• Check the softener lid is secure.
• Interrupt the programme and
rearrange the items which are
obstructing the spray arm.
• Interrupt the programme and
rearrange the items of crockery.
• This has no influence on the
dishwasher function. If in doubt,
contact a qualified plumber.
• See notes in "Loading &
unloading your dishwasher".
• Select a more intensive
programme.
• Use more detergent, or change
your detergent.
• Rearrange the items so that the
spray can rotate freely.
• Clean and/or fit the filter
correctly
• Clean the spray arm jets.
EN
What To Do