Snow Joe SUNJOE 24V-PRN1-CT Manual Del Operador página 9

Fig. 12
90°
3. Slide the battery into the removable battery compartment
until it clicks into position (Fig. 13).
Fig. 13
4. To use the pole pruner, balance your weight with both feet
on solid ground and hold the pole pruner by one hand on
the rear handle and the other on the pole. Position the
tool at an angle so as to stand away from falling debris
(Fig. 14).
Fig. 14
POLE PRUNER MODE
-45°
-22.5°
0°
22.5°
45°
67.5°
POLE PRUNER MODE
Battery pack
Removable battery
compartment
5. Grip the rear handle of the pole and squeeze the safety
lock button to unlock the trigger. When you are ready to
make a cut, pull the trigger to close the blades. Release
the trigger to open the blades (Fig. 15).
Fig. 15
Safety lock button
Trigger switch
Trimming Tips
The pruner can be used to remove fresh blooms, overgrowth,
dead and tangled stems, as well as twigs and weak growth.
1. Never cut too close to the bud, so the wound can heal
properly.
2. Make the cut approximately 0.3 inch (8 mm) above the
bud (Fig. 16).
Fig. 16
3. The cut should slope away from the bud, so that rainwater
can be channeled away from it (Fig. 17).
Fig. 17
9
POLE PRUNER MODE
0.3 inch (8 mm)
Bud