Machine Information; Technical Specifications - VONROC ID503AC Traducción Del Manual Original

Always check that the power supply
corre sponds to the voltage on the rating plate.
Class II machine - Double insulation -
You don't need any earthed plug
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk
of electric shock.

2. MACHINE INFORMATION

Intended use
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
No-load speed (1)
No-load speed (2)
Impact rate (1)
Impact rate (2)
Chuck size
Max. drill diameter Wood
Concrete
Steel
Weight
Sound pressure level L
PA
Sound power level L
WA
Drilling into metal, a
h,D
Impact drilling into concrete, a
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN62841; it
may be used to compare one tool with another
and as a preliminary assessment of exposure to
vibration when using the tool for the applications
mentioned.
• Using the tool for different applications, or with
WWW.VONROC.COM
ID503AC
220-240 V~
50/60 Hz
1100W
0-1.200/min
0-3.100/min
0-19.200/min
0-49.600/min
13 mm
30 mm
20 mm
13 mm
3.3 kg
94 + 3 dB(A)
105 + 3 dB(A)
4.156 + 1.5 m/s
2
11.897 + 1.5 m/s
2
h,ID
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
Fig. A
1. Chuck
2. Function selection switch
3. Depth stop
4. Lock-on button
5. On/Off switch
6. Speed adjustment wheel
7. Left/right rotation switch
8. Gear selection switch
9. Side handle
Fig. B
10. Rear sleeve
11. Front sleeve
3. ASSEMBLY
Mounting and removing the auxiliary grip (Fig. A)
Mounting
• Loosen the auxiliary grip (9).
• Slide the auxiliary grip (9) over the chuck (1).
• Turn the auxiliary grip (9) to the required position.
• Tighten the auxiliary grip (9).
Removing
• Loosen the auxiliary grip (9).
• Remove the auxiliary grip (9) from the chuck (1).
Exchanging and removing drill bits (Fig. A ­ B)
The machine is suitable for use of the following
drill bits:
• Wood (HSS)
• Metal (HSS)
• Concrete / masonry (hard metal)
Before exchanging bits, first remove the
power plug from the wall socket.
EN
5