Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.
Turn the lower shaft until the button locks into the
positioning hole.
5.
Tighten the screw with the hex wrench (4).
1
2
8.4
ATTACH THE AUXILIARY HANDLE
1.
Remove the knob (1) from the handle.
2.
Attach the auxiliary handle and lower clamp (2)
on the shaft.
3.
Set the auxiliary handle in the comfortable
position.
4.
Put the bolt (3) through the holes.
5.
Tighten the auxiliary handle with the knob.
2
8.5
ATTACH THE SHOULDER STRAP
1.
Attach the carabiner to the carrying ring on the
drive tube.
English
3
4
3
1
2.
Put on the shoulder strap.
3.
Adjust the length of the strap so that the
carabiner is about a hand's width below your right
hip.
8.6
INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1.
Align the ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
3.
When you hear a click, the battery pack is
installed.
8.7
REMOVE THE BATTERY PACK
1.
Push and hold the battery release button (1).
2.
Remove the battery pack from the machine.
8
WARNING
Publicidad
Tabla de contenido
Solución de problemas
