General Notes - Jacuzzi Chelsea Projecta Manual De Instalación - Uso - Mantenimiento

GENERAL NOTES:

Never use water at temperatures over 60 °C to prevent dam-
age to the plumbing circuit.
NOTE: It is also possible to use two functions at the same time.
Just position the diverter dial (G) half way between the two
functions.
A
E
R
38°
Before you use any function, you should adjust the water tempera-
ture to the value you want by doing the following:
■
Turn the dial (M) so that the notch matches up with the cho-
sen value. The knob is provided with a safety lock that fixes the
temperature at 38 °C. To select higher temperatures, push the
button (P).
■
If you wish to try the water temperature, turn the diverter dial
(G) to the "foot nozzle" (D) position and turn the stop tap (R) to
let water run.
■
Once the required water temperature has been reached, turn
the dial (G) to the position that indicates the function you want
to use
Remember to turn off the stop tap after each use (R). If tem-
peratures above 38 °C have been selected, it is advisable to
turn back the thermostatic mixer dial to the position before
the safety lock.
B
C
D
G
M
P
A
E
Before you use any function, you should adjust the water tempera-
ture to the value you want by doing the following:
■ Turn the dial (G) of the diverter to the "foot nozzle" position (D).
■
Raise the lever of the mixer (M) and turn it to the right or left
until a desirable temperature is reached.
■
Once the required water temperature has been reached, turn
the dial (G) to the position of the function you want to use
Before using the electronic functions, make certain that the main
switch installed prior to the appliance (please see the chapter on
"Electrical Safety") is turned on. In any case, when the shower enclo-
sure is powered the LED (4) on the display is on.
1
14 14
B
C
D
G
M
4
3
2