Connecting Usb Devices - Makita DCJ205 Manual De Instrucciones

Indicator lamps
Lighted Off
(For 14.4 V and 18 V batteries only)
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Battery BL1055B
While the battery BL1055B is unplugged, press the
power button. The battery capacity indicator light up for
a few seconds.
Fig.14
► 1 . Power button 2. Battery capacity indicator
Meaning of the indicator lamp
Indicator lamps
Lighted Off
Remaining
capacity
Blinking
The battery
may have
malfunctioned.
2 1
Remaining
capacity
Blinking
50% to 100%
25% to 50%
10% to 25%
Less than
10%
Battery
abnormality
Battery protection system
The device is equipped with a battery protection sys-
tem. This system automatically cuts off power to the
heating parts to extend battery life. If the remaining
battery capacity is too low, the device will not operate.
When you turn the device on, the power is supplied to
the heating parts again, but stops soon. In this situation,
remove and recharge the battery cartridge.

Connecting USB devices

CAUTION:
Connect only devices that are
compatible with the USB power supply port. Not
doing so may cause a malfunction of the battery
holder.
NOTICE:
Before connecting a USB device,
always back up the data on the USB device. Not
doing so may cause a loss of your data.
NOTICE:
The battery holder may not supply
power to some USB devices.
NOTICE:
When not using or after charging,
remove the USB cable and close the cover.
NOTE: The actual output current varies depending on
the USB device to be connected.
NOTE: Battery power is consumed while the power
button is turned on. Always turn off the switch when
not in use.
NOTE: When charging multiple USB devices in suc-
cession, wait about 10 seconds after charging of the
previous device has completed before beginning to
charge the next device.
The battery holder (with the battery cartridge) can work
as an external power supply for USB devices.
1.
Open the cover and connect a USB cable (not
included) to the USB port. Then connect the other end
of the cable to the device.
2. Start charging:
— When using battery holder (with the battery), press
and hold the power button until the power level
indicator lights up. The battery supplies DC 5 V,
2.4 A.
Battery holder (with battery)
Fig.15
► 1 . Cover 2. USB port
11 ENGLISH
2
1