Technical Data; Charging The Battery - Würth 42 LEDs Traducción De Las Instrucciones De Uso Originales

GB
Operation
4
1. Light output – Spot light and main light
2. Indicator light
3. Hook - extandable
4. USB connection – power supply and USB-cable
for charging the lamp included in the delivery
5. On/Off switch – 1. step: Spot light
2. step: Main light

Charging the battery

• Before taking the hand lamp into service for the
first time charge it for 6-8 hours
• Fully charge the hand lamp before it is stored for
a longer period.
• Switch lamp off during charging.
• Remove the protective cap from the connector
(4) and connect the cable or charger.
• Connect the power supply to the mains socket
(100-240 V~).
• The indicator light (2) of the lamp switches to
RED during charging.
• If charging is completed, the indicator light (2)
of the lamp switches to GREEN.
• If the indicator light (2) does not turn
CONSTANT RED, unplug the charger and then
try again.
• Do not charge the battery longer than required
to prevent overheating.
• Disconnect the charger and attach the protective
cap for connector (4).
8
3
1 2
1
1
5
Notes regarding operation
The switched-on lamp is very bright and the lamp
may get hot in the vicinity of the light outlet. When
the lamp is switched on:
• do not look directly into the light outlet.
• ensure that nobody is exposed to glare.
1
• do not cover the light outlet.
• do not put down the lamp with the light outlet
pointing downwards.
Art.
Number of LEDs:
Operating voltage
power supply unit:
Lamp input voltage/
current consumption:
Charging time:
Operating time (main light):
Operating time (spot light):
LED intensity (main light):
LED intensity (spot light):
Service life of LED:
Degree of protection:
Storage temperature:
Operating temperature:

Technical data

0827 940 16X
42+1, 7+1W
Li-Ion, 3.7V,2600mAH,
9.62Wh
100-230 V~ / 50-60 Hz
5 V 1 A
approx. 3.5 hours
3.5 hours
9 hours
450 lm
100 lm
up to 10000 hours
IP 65
–20 °C to +45 °C
–10 °C to +40 °C