Technical Data; For Your Safety; Safety Instructions; Specified Conditions Of Use - Würth WLH 1.4 Traducción Del Manual De Instrucciones De Servicio Original

GB
RECHARGEABLE LED HANDLAMP
Art.
Number of LEDs:
batteries
Supply voltage power supply unit
Frequency power supply unit
Charging time
Lighting duration
LED light-Lifetime
Type of protection
Storage temperature
Operating temperature

For Your Safety

Please read and comply with these operating
instructions prior to initial operation of your
device. Keep these operating instructions for
later use or for a subsequent owner.
Warning!
Risk of injury to the eyes
•
Do not look into the lamp when it is switched on.
•
Make sure that no one is blinded.
Only use the charger recommended by the manufacturer
to charge the lamp. Use of a charger that is NOT recom-
mended may cause a fire and destroy the lamp.
Prior to first use always read the safety instructions! Failure
to observe the operating instructions and the safety instruc-
tions could result in damage to the appliance and danger
for the operator and other persons.

Specified Conditions of Use

The lamp is used as intended if it is used exclusively to illuminate
ordinary work areas and if the specifications stated in the
technical data are observed. Any other use or use beyond
this is not permitted.
The appliance must not be used:
•
in areas with harmful gases, oils, acids, radiation, etc.
•
in potentially explosive atmospheres
This lamp complies with all relevant norms and standards
in connection with CE conformity. If the lamp is modified,
compliance with these standards is no longer guaranteed.
It is forbidden to make any changes to the device. Such
changes can lead to personal injury and malfunctions.
12

Technical Data

WLH 1.4
0827 940 114
6x 0,5 W SMD
Lithium ion, 3,7 V, 2.000 mAh
100–240 V AC
50/60 Hz
∼5 h
∼4 h
until 50.000 h
IP65
-20 °C ... +45 °C
-5 °C ... +40 °C
Warning against hot surfaces! The lamp
can become hot in the area of light emis-
sion. Therefore, keep a distance of at least
•
Do not cover the light emission.
•
Do not place the lamp with the light emission pointing
downwards.
•
Do not open the lamp.
•
There is a risk of a short circuit. Repairs to the lamp may
only be carried out by persons authorised and trained for
this purpose. Contact your Würth branch.
A damaged lamp or charger may no longer
be used and may only be replaced by the
manufacturer.
•
Charge before first use. Charging time: 6-8 h
•
Fully charge the fixture before storing it for an extended
period of time.
•
Switch off the light during charging.
•
Remove protective cap
•
Plug the power supply unit into the lamp.
•
During the charging process, the LED of the light
switches to red.
•
The charging process is completed as soon as the LED
of the light switches to green.

Safety Instructions

Charge the Battery