Trust ACM-3500-3 Manual De Instrucciones página 6

ACM-3500-3 3-IN-1 BUILD-IN SWITCH
EN
1. Switch off the mains power (electric meter box)
2. Connect the live wire and neutral wire to [IN]
Connect the (brown) live wire to [L]. Connect the (blue) neutral wire to [N]. Contact an electrician when
in doubt about wiring. Tighten the clamping screws.
3. Connect lamp/device wiring to [OUT]
For each lamp/device, connect 2 wires to the [L] and [N] contact of output I, II or III. Contact an
electrician when in doubt about wiring. Tighten the clamping screws. Do not exceed the total
maximum load: 3500W.
4. Switch on the mains power (electric meter box) to continue the installation
Shock hazard! Do not contact any exposed wiring. Only touch the plastic housing of this product.
5. Activate learn-mode
Press the learn-button of port I, II or III on the receiver for 1 second. The learn-mode for this port will
be active for 15 seconds and the LED-indicator will blink slowly.
6. Assign Trust Smart Home transmitter code
While the learn-mode is active, send an ON-signal with any Trust Smart Home transmitter to assign
the code to the receiver's memory.
7. Code confirmation
The receiver will switch on/off 2 times to confirm the code has been received. Per port, the receiver
can store up to 6 different transmitter codes in its memory. The memory will be preserved when the
receiver is moved to another location or in case of power failure.
8. Affix the receiver
Secure the receiver to a surface for extra stability. For outdoor use, mount the receiver in a waterproof
junction box and cover up any exposed wiring.
1