Cooper Lighting Solutions WaveLinx Pro WAC2-POE Instrucciones De Instalación página 2

WaveLinx Pro
SAVE THESE INSTRUCTIONS
This installation instruction is for the Wireless Area Controller (WAC2-POE) which enables user control of the WaveLinx Pro Connected
Lighting System and devices via local control or through the WaveLinx Pro Mobile application.
The purpose of this document is to provide sufficient detailed instructions for installation and basic troubleshooting.
This document covers installation of the following products.
• WAC2-POE Wireless Area Controller, POE powered
• WAC2-120 Wireless Area Controller, 120V (includes PoE injector for power)
Note: WAC2-POE may be powered from a PoE injector. If an injector is used, WPOE2-120 from Cooper Lighting Solutions is required.
WAC2-120 includes both the WAC2-POE and the WPOE2-120 injector.
WaveLinx Pro Connected Lighting System Architecture
Figure 1. Stand Alone WAC installation
120V Power
PoE Injector
Network
Switch
WaveLinx Pro
Touchscreen
IB503099ML page 2
December 2021
WaveLinx Pro
Wireless Area
Controller
Area or Room
(49 + 1 construction area)
120-347V 20A Room Based
Dimming Switchpacks Occupancy Sensor
WaveLinx Pro wireless controlled devices
(up to 200 devices per WAC2 - 150 devices best practice) - see Note
WaveLinx Pro Mobile App
used for system setup
and personal control
Controlled Scene Integrated
Receptacle Wallstation Ambient
Wireless Area Controller (WAC2-POE)
KEY
Wi-Fi Signal
IEEE 802.15.4
Integrated
Outdoor
Note:
Performance based on second generation
WaveLinx Pro Wireless Area Controller (WAC2)
www.cooperlighting.com