Problem Solution - VATTON 48258 Manual De Instrucciones

EN
TIPS FOR MAINTAINING MAXIMUM
BATTERY LIFE
1. Charge the battery cartridge before completely dischar-
ged.
Always stop tool operation and charge the battery cartridge
when you notice less tool power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room temperature at
10 º C - 40 º C (50 º F - 104 º F). Let a hot battery cartridge
cool down before
charging it.
4. Charge the battery cartridge once in every six months if
you do not use it for a long period of time.

PROBLEM SOLUTION

1. I CANNOT FIT THE BATTERY INTO
THE BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot.
2. REASONS FOR DIFFERENT BATTER PACK
WORKING TIMES.
Charging time issues, as above, and having not used a
battery pack for a porlonged time will reduce the wor-
king life of the battery pack. This can be corrected after
several charge and discharge operations by charging &
working with your drill. Heavy working conditions such as
large screws into than lighter working conditions. Do not
re-charge your battery pack below 0ºand above 50º as this
will affect performance.
3. HOT BATTERY PACK PROTECTION.
The normal charging temperature is between 0º and
50º. When the battery pack is too hot, it automatically starts
a HOT battery pack delay, and suspends charging until it
has reached the correct temperature. The charging process
will then automatically begin.
4. BATTERY PACK OVERLOAD AND
LOW-VOLTAGE PROTECTION.
When max. allowable battery current is exceeded during
working, the overload protection is activated to protect
the battery against overheating.When the battery is under
normal voltage during working, the power tool will cease
to operate.
MAINTENANCE
CAUTION:
- Always make sure the tool is turned off and the battery
cartridge removed before attempting inspection or main-
tenance.
- Never use gasoline, benzene, thinner, alcohol or the like. It
can result in discoloration, warping or cracking.
CLEANING
From time to time, wipe the outside of the tool with a cloth
dampened in soapy water.
Any problem with the machines, please contact us.
SYMBOLS
Read the manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries.
Return exhausted batteries to your local
collection or recycling point.
6