Air Cursors - avdel 07536 Manual De Instrucciones

P u t t i n g i n t o S e r v i c e
A i r C u r s o r s
Air Cursor Selection
See separate data sheet 07900-00863 for nose assembly components.
C u r s o r
If fitted incorrectly, the cursor will not allow the loading of the tool and feeding of the fasteners.
While the cursor will be fitted the correct way round when the tool is supplied, we recommend that you check its orientation before
fitting the nose equipment. The slightly concave end of the cursor should point towards the front of the tool as shown in the
illustration.
To reverse the orientation of the cursor, follow these steps:
Extreme caution must be exercised whe undertaking the following procedure. Care must be taken to avoid the barrel and protruding
mandrel.
•
Remove the Nose Assembly if there is one.
•
Insert an empty mandrel fully into the tool.
•
Close the Tail Jaws 32, by switching on the tail jaw switch (items
18 and 19).
•
The cursor will pop out of the barrel after a short delay.
•
Open the Tail Jaws 32, by switching off the tail jaw switch (items
18 and 19), this will release the mandrel.
•
Remove the cursor from the mandrel and insert the cursor into
the barrel.
Item numbers in bold refer to the general assembly and parts list for the 07536-02200 Tool on pages 16-17.
8
TOOL
BARREL
IMPORTANT
CONCAVE END
CURSOR
NOSE
JAWS
CURSOR
BARREL
NOSE
JAWS
TOOL