HOGERT HT4M322 Instrucciones De Uso página 12

Press the key
mode, press the key
and the cumulative value of both measurements. The last measured value and the current measured
value is displayed in the secondary display area, and the cumulative value of the two is displayed in the
main display area. Press the key
measurement mode, press the key
measured value and the cumulative subtraction value of both, the last measured value and the current
measured value is displayed in the secondary display area, the cumulative subtraction value of both will
be displayed in the primary display area.
• Addition and subtraction of surfaces
The first value of the area is measured according to the surface measurement method as shown in Figure
1. Press the key
value of the field is measured according to the surface measurement method. The result is shown in Fig.
3. Finally, press the key
the area are displayed in the secondary display area, the results of the addition are displayed in the main
display area, as shown in figure 4.
The first value of the field is measured according to the method of measuring the field, as shown in Figure
Fig.1
5. Press the key
the area was measured according to the area measurement method and the results are shown in Fig. 7.
Finally, press the key
measured areas from the last two times are displayed in the secondary display area and the subtraction
results are displayed in the main display area, as shown in Figure 8
Fig.5
• Volume addition and subtraction
Volume summing and subtraction operation is similar to area accumulation / subtraction operation
• Notes
12 Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
, until the additional display (third line) shows „+". Enter the cumulative measurement
the screen will display the last measured value and the current measured value
, duntil the additional display (third line) shows „-", enter subtraction
, the screen will display the last measured value and the current
, until the display screen (third line) shows a „+" as shown in figure 2. The second
, to get the results of the measured plots. The last two measured values of
Fig.2
until the display screen (third line) shows „-" as shown in Fig.6. The second value of
, to get the difference of two measured surface values. The values of the
Fig.6
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
Fig.3
Fig.7
Fig.4
Fig.8