GGP TB 25 Manual De Instrucciones página 36

34
EN
EXTRAORDINARY MAINTENANCE
Contact your local Authorised Service Centre for
any procedures not considered to be ordinary
maintenance.
Repairs carried out by unauthorised service cen-
tres and unqualified personnel will invalidate the
warranty.
ONLY USE AND REQUEST ORIGINAL SPARE
PARTS.
STORAGE
IMPORTANT
instruction oily deposits may form in the carbu-
rettor, making starting difficult or causing perma-
nent damage due to disuse of the brush cutter.
1. Clean the outer part of the engine, the drive
assembly, the guard and the line head.
2. Empty the fuel tank.
3. After emptying the fuel tank start the engine.
4. Run the motor at minimum speed until it stops
to remove all fuel from the carburettor.
5. Allow the engine to cool (about 5 minutes).
6. Use the specific key to remove the spark plug.
7. Pour in 1 teaspoonful of 2-stroke engine oil
(new oil). Pull the starter cord a few times to
cover the internal components with a layer of
oil. Refit the spark plug.
8. Store the brush cutter in a cool, dry place, far
from sources of heat (such as radiators, boil-
ers, etc.) or naked flames.
PREPARING THE BRUSH CUTTER AFTER
STORAGE
1. Remove the spark plug.
2. Pull the starter cord vigorously to remove
excess oil from the combustion chamber.
3. Clean and check the gap (distance between
electrodes) of the spark plug or fit a new spark
plug with a suitable gap.
4. Prepare the brush cutter for use
5. Fill the tank with suitable fuel. See paragraph
FUEL AND LUBRICANT.
If you do not follow these
ALL OUR MACHINES ARE TOP QUALITY. THEY
ARE PERFECTLY TUNED AND ARE DESIGNED
SO THAT THE OPERATOR CAN WORK IN MAX-
IMUM SAFETY.
– NEVER TAMPER WITH MACHINES
– NEVER WORK WITH MACHINES WITH MISS-
ING OR DAMAGED PARTS.
– Do not cause disturbance to the natural
environment and those around you.
– Always work in safety.
– Avoid hazardous situations.
– Never work alone, especially in remote
areas.
– Take care over those around you and
possible dangers.
– Always wear personal protective gar-
ments.
– Only work with appropriate saws to safe-
ty standards and which have been sub-
jected to regular accurate servicing per-
formed by a skilled person!!!
– RESPECT THE ECOSYSTEM!!
NORMAL MAINTENANCE