Before First Use - Rowenta DR71 Serie Manual De Instrucciones

Ocultar thumbs Ver también para DR71 Serie:
Tabla de contenido

Publicidad

Before first use

• When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small
discharge of particles. This will not affect the use of the appliance and will disappear quickly.
What water to use?
• Your appliance has been designed to use tap water.
If your water is very hard (hardness above 30°F, or 17°dH or 21°e), mix 50% tap water and 50% bottled
demineralised water. Never use water containing additives (starch, perfume, aromatic substances, softeners, etc.), or
condensation water (for example water from tumble dryers, water from refrigerators, water from air conditioning
units, rainwater). Do not use pure distilled nor pure demineralised water. Such water contains organic waste
materials or minerals that concentrate under the effect of heat and cause spitting, brown colouring or premature
ageing of your appliance.
SAVE THESE INSTRUCTIONS
Environment protection first !
i
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
14
Problems with your iron?
PROBLEM
POSSIBLE CAUSES
There is no steam.
The appliance is not plugged in, or
not switched on.
The water level is too low.
The steam pump has not been
primed.
You are using the appliance for the
first time.
The water tank is not fully in place.
The appliance does
It is not plugged in, or not swit-
ched on.
not heat.
Water leaks.
The water tank is not fully in place or
the stopper is not closed properly.
Steam rate decreases.
Calc has built up in the appliance.
The steam leaves stains
You are using water with additives.
on the fabric or the
appliance spits.
The appliance has not been rinsed
enough after the descaling
operation.
You are using other liquids than
white vinegar to descale the pro-
duct.
*
You scrub too tightly the textile.
Micro fiber brush
support is removed from
the steam head / from
the micro fiber brush
support .
* Depending on model
SOLUTIONS
Check that your appliance is correctly
plugged in and switched on.
Unplug your appliance and refill it.
Press the steam trigger continuously
until the steam appears.
Press the steam trigger continuously
until the steam appears.
Ensure that inlet stopper is closed
and that the water tank clicks/locks
when put into place.
Plug in your appliance and switch on.
Ensure that inlet stopper is closed
and that the water tank clicks/locks
when put into place.
Refer to 'ANTI CALC section in
instructions for use.
Never add any additive in the water
tank.
Refer to ''WHAT WATER TO USE''
section.
Read carefully the 'ANTI CALC' section
in instructions for use.
Use only white vinegar during 'ANTI
CALC' procedure.
Refer to the ''ANTI CALC'' section in
the instructions for use.
Scrub softly the textile to remove
inpregnated dust.
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dr7130

Tabla de contenido