Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USE
•
Put the mains plug in an earthed wall socket.
•
Carefully pull the pan out of the aerofryer.
•
Put the ingredients in the pan, make sure the aeroplate
(removable grid) is placed in the pan before you put in the
ingredients.
•
Slide the pan back into the aerofryer.
•
Do not touch the pan during and some time after use, as it gets
very hot. Only hold the pan by the handle.
•
There are 8 frying programs included: Aerofryer fries, Shellfish/
Crustaceans, Fish, Chicken, Muffin, Bake, Onion rings and
Steak. Use the mode button to select the desired program.
•
When you press the power button, the aerofryer will start the
corresponding program. When you have chosen the wrong
program, you can abort by pressing the power button again. The
device will stop after 20 seconds. After this you can select
another function. It is also possible to adjust the chosen program
by changing the time and temperature.
•
The time can be adjusted with the timer control buttons. Press
the timer control buttons one time to increase or decrease the
frying time by one minute. Press and hold one of the buttons to
adjust the time faster. You can set the timer between 1 and 60
minutes.
•
The temperature can be adjusted with the temperature control
buttons. Press the temperature control buttons one time to
increase or decrease the temperature by 5 degrees. Press and
hold one of the buttons to adjust the temperature faster. You can
set the temperature between 80 and 200 degrees.
•
It is also possible to start the device without selecting a function.
Set the time and temperature with the timer and temperature
control buttons, then press the power button.
•
When you pull out the pan during the frying process, the device
will shut off automatically. When you reinsert the device, the
program will resume.
•
To cancel any program, press the power button. The device will
shut off after 20 seconds.
•
During the hot air frying process, the heating-up light will blink
during heating, when the set temperature is reached the heating-
up light will stay on continuously. When the temperature drops
below the set temperature the heating-up light will start blinking
again to maintain the set temperature.
•
Excess oil from the ingredients is collected on the bottom of the
pan.
•
Some ingredients require shaking halfway through the
preparation time. To shake the ingredients, pull the pan out of the
appliance by the handle and shake it. Then slide the pan back
into the air fryer. Do not press the basket release button during
shaking
•
When you hear the timer beep, the set preparation time has
elapsed. The device will shut off after 20 seconds. Pull the pan
out of the appliance and place it on a heat-resistant surface.
•
Check if the ingredients are ready. If the ingredients are not
ready yet, simply slide the pan back into the appliance and set
the timer to a few extra minutes.
•
To remove small ingredients (e.g. fries), first push the release
button cover forward to expose the basket release button. Press
the basket release button and lift the basket out of the pan. Do
Instruction manual
EN
5
Publicidad
Tabla de contenido
