INSTALLATION GUIDES- LUPOL01
INSTALLATION INFORMATION
Installation must be carried out in
accordance with national standards.
The fi xture must only be used when
complete with safety screen. If the
screen is damaged or broken, the fi xture
must not be used. Restore the original
conditions before reusing.
The fi xture is installed under CL II (or
CL I) protection standards, particular
care must be taken while assembling to
ensure that exposed metal parts do not
come into electrical contact with parts of
the electrical installation connected to
a protection conductor. This light fi xture
must be installed only for the use for
which it was designed, namely for the
illumination of outdoor spaces.
Any other use must be considered to
be improper and dangerous, and the
manufacturer cannot be held liable for
any damage caused by improper and
unreasonable use.
Installation
Unscrew the two screws (M6) from the
upper frame (Fig. 1-2) and lift the cover
(Fig. 3-4). Unscrew the two screws (M8),
the two nuts and the four washers from
the attachment on the upper frame
(Fig. 5). Bring the pole attachment closer
(Fig. 6) and check the desired tilt angle
adjustment (0°/+20° or 0°/-20° in 5°
steps) (Fig. 7-8-9).
Attach the coupling with the notched part
to the device and screw in the two screws
(M8), the two nuts and the four washers
(Fig. 10).
Electrical connection
Insert the cable into the pole connection
(Fig. 11) and connect the power cable
(Fig. 12-13). If the external fl exible cable
of this appliance is damaged, it must
only be replaced by the manufacturer,
its service agent or a qualifi ed person to
avoid danger.
Attaching the luminaire to the support
Insert the device, complete with already
connected cables, into the holder (Fig. 14).
Place the cover back on the upper frame
and screw in the two screws (M6) (Fig. 15).
Orient the device correctly in relation to
the road axis (Fig. 16).
Tighten the two grub screws (M8) on the
device connection and secure the grub
screws with the nuts. (Fig. 17).
EN
neri.biz
25