Rothenberger ROCAM mini HD Instrucciones De Uso página 28

4.3 Changing the battery
 Insert the battery into the receptacle on the back of monitor unit (5) until it clicks into place.
To remove, press the battery release (11) and pull the battery out.
4.4 Installation ROCAM mini HD Haspel or Modul ROLOC PLUS HD
Only one device should be connected to the unit at a time. Always make sure the unit is
off when installing or removing imagers or other accessories!
The plug of the camera cable must be connected to the monitor unit in order to use the ROCAM
mini HD reel or ROLOC PLUS HD. To secure connector, make sure the key and slot are proper-
ly aligned. Once they are aligned, hand-tighten the knurled nut to hold the connection in place.
4.5 Working with the device
Wear protective clothing! Always stand next to the reel cable!
 Push reel cable (4) with bending spring (3) from the holder (8).
Caution: Check for cleanliness and damage!
 If necessary, additional accessories can be attached to camera. When using pipe diameters
greater than 70 mm, always use guide body!
 Clean the pipe system before inspection.
 Turn the device on with the Power-button (5.1) located on the monitor (5).
Excessive pressure on the touch screen may damage the monitor unit!
 Remove the camera head (1) from the holder (8) and pull the cable (4) from the reel (6). The
cable is rigid and is under mechanical stress. Therefore, hold it firmly when unwinding from
the reel.
 Guide the camera head (1) into the pipe system and carefully push it with the cable (4).
Do not pull the cable (4) over sharp edges, and do not bend it!! Check the camera cable
before each use for damage!
While it is being pushed, the cable (4) may loop: Breakage may result!
With self-leveling activated, the camera image is always upright while advancing through multi-
ple pipe bends.
 After work is finished, pull the cable (4) out of the pipe and push it directly onto the reel (6).
Remove coarse dirt and water with a rag while winding cable on reel.
 Perform cleaning (see section 5).
4.6 ROCAM positioning
The positioning probe is built in the camera head spring. The positioning probe emits magnetic
fields that are received by the positioning receiver and are transformed visually and audibly.
The 512 Hz measuring system can penetrate masonry, stone, wood and plastic.
The intensity of the signal changes depending on the position and distance from the receiver.
4.7 Monitor unit with touchscreen
The ROCAM mini HD comes with a SD card to save photo's and video's. This can be removed
for data transfer.
Connections HDMI, mini USB and SD card are on the bottom monitor unit.
22 ENGLISH