Publicidad
Idiomas disponibles
Idiomas disponibles
TURBO NOZZLE + 20-INCH ROD
ASSEMBLY QUICK GUIDE
NOTE: Below instructions are only for connecting with SUN JOE
corresponding transfer adapter. Check page 2 for details.
SPX200/SPX1000 Series
Trigger Gun
SPX2000, SPX2500, SPX2600, SPX4003, SPX4003-ULT
Trigger Gun
Most SPX2000 Series + SPX4003-ELT, SPX7001E
Trigger Gun
Most SPX3000 Series + Most SPX4000 Series
Trigger Gun
m WARNING
*
For safety reasons, the nozzle must be used with the 20-inch rod.
FOR USE WITH SPX200/SPX1000 SERIES:
1. Disconnect your spray wand assembly so that only the middle wand remains attached to your trigger gun.
2. Take the 20-inch rod and align with the middle wand.
3. Once aligned, push the 20-inch rod into the middle wand and and twist to lock into place (follow the arrow in the image).
4. Align turbo nozzle and push into the 20-inch rod and and twist to lock into place (follow the arrow in the image).
FOR USE WITH SPX2000, SPX2500, SPX2600, SPX4003, SPX4003-ULT:
1. If not already done, detach your spray wand from your trigger gun.
2. Take the 20-inch rod and align the with the trigger gun.
3. Once aligned, push the 20-inch rod into the trigger gun and twist to lock into place (follow the arrow in the image).
4. Align turbo nozzle and push into the 20-inch rod and and twist to lock into place (follow the arrow in the image).
FOR USE WITH MOST SPX2000 SERIES + SPX4003-ELT, SPX7001E:
1. If not already done, detach your spray wand from your trigger gun.
2. Take the 20-inch rod and align the with the trigger gun.
3. Once aligned, push the 20-inch rod into the trigger gun and and twist to lock into place (follow the arrow in the image).
4. Align turbo nozzle and push into the 20-inch rod and and twist to lock into place (follow the arrow in the image).
FOR USE WITH SPX3000 SERIES + Most SPX4000 SERIES:
1. If not already done, detach your spray wand from your trigger gun.
2. Attach the transfer adapter to your trigger gun.
3. Take the 20-inch rod and align the two tabs with the transfer adapter.
4. Once aligned, push the 20-inch rod into the metal gun transfer adapter and and twist to lock into place (follow the arrow in the image).
5. Align turbo nozzle and push into the 20-inch rod and and twist to lock into place (follow the arrow in the image).
®
Pressure Washers. For connecting with other brands' pressure washers, use
Middle Wand
Metal Gun
Transfer Adapter
m WARNING
5
*
20-Inch Rod
20-Inch Rod
20-Inch Rod
20-Inch Rod
For domestic use only. Do not use with commercial grade pressure washers.
Turbo Nozzle
Turbo Nozzle
Turbo Nozzle
Turbo Nozzle
Publicidad
