Tabla De Contenido; Connections - Aiwa XC-37M Manual De Instrucciones

TABLE OF CONTENTS
PRECAUTIONS ................................................................... 1
PREPARATIONS
CONNECTIONS .................................................................. 2
BEFORE OPERATION ........................................................ 3
REMOTE CONTROL ........................................................... 3
CD PLAYING
BASIC OPERATIONS ......................................................... 4
RANDOM/REPEAT PLAY ................................................... 5
PROGRAMMED PLAY ........................................................ 6
RECORDING
AI EDIT RECORDING ......................................................... 7
PROGRAMMED EDIT RECORDING .................................. 8
GENERAL
CARE AND MAINTENANCE .............................................. 9
SPECIFICATIONS ............................................................... 9
PARTS INDEX ................................................................... 10
Owner's record
For your convenience, record the model number and serial
number (you will find them on the rear of your set) in the space
provided below. Please refer to them when you contact your Aiwa
dealer in case of difficulty.
Model No.
XC-37M
Serial No. (Lot No.)
PREPARATIONS

CONNECTIONS

Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is 120 V
AC. Check that the rated voltage shown on the rear panel matches
your local voltage.
IMPORTANT
• Insert plugs firmly into the jacks. A loose connection may cause
noise.
• Connect AC cords after connecting all equipment.
• Consult the operating instructions of the connected equipment
before making connections.
CONNECTING TO AN AMPLIFIER
XC-37M
Amplifier
1 Connect the amplifier.
Connect the red plug to the AUDIO OUT R jack and white
plug to the L jack with the supplied audio connecting cord
with RCA phono plugs. Likewise connect the plugs to the CD
or AUX IN jacks of the amplifier.
2 Connect the AC cords to AC outlets.
CONNECTING TO DIGITAL OUT (OPTICAL)
JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (digital
amplifier, DAT deck, MD recorder, etc.).
Remove the dust cap a from the DIGITAL OUT (OPTICAL) jack.
Then, connect an optical cable plug b to the DIGITAL OUT
(OPTICAL) jack.
When the DIGITAL OUT (OPTICAL) jack is not being used
Attach the supplied dust cap.
En
2
ENGLISH