lock of hair before the beep.
In any case, the experience gradually gained in using the appliance
will help you establish the styling time for your type of hair in order to
achieve the desired effect. The product makes it possible to select the
EN
winding direction according to the desired curl direction.
To maintain the result obtained do not brush or comb your hair before
it has cooled.
INSTRUCTIONS FOR USE
• Connect the power cord (7) to the mains and position the appliance on a
smooth and heat resistant surface.
• Set the desired temperature level by means of the switch-on and
temperature selection button (0- 190°C- 220°C) (6):
• 190°C to obtain soft waves
• 220°C to obtain more clearly defined wavy hair
• The LED indicator (4) will turn red and it will beep on switch-on. The LED
indicator (4) will turn blue and it will beep again when the styler has reached
the selected temperature.
• Position the product parallel to the lock of hair or slightly tilted.
(Image A). Do not position the product horizontally.
• Take a lock of hair between your fingers as wide as you wish, move it close
to the heated barrel (2) and insert it between the heated barrel (2) and the
internal support (3A) (Image A).
• Press the rotation button in the desired direction (5): the automatic rotation
system support (3) rotates and automatically wraps the lock of hair around
the heated barrel (2) (Image B1).
• Hold the button down until the lock of hair is completely wound around the
heated barrel (Image B) and in any case longer than 3 seconds to allow the
styling time buzzer to operate properly.
• Hold the appliance in position and wait for the buzzer; extract the appliance
downwards while holding it vertical. Do not tilt it diagonally (Image C).
• Repeat these steps on various locks of hair until achieving the desired
styling. Once the hair styling operation is completed, switch off the
appliance by moving the switch-on button (6) to position 0 (off) and
disconnect it from the power socket.
• For cooling, place the appliance in a dry and safe place on a heat-resistant
surface. Keep out of the reach of children.
NOTES:
• Steam may be emitted while the appliance is used; this is excess
humidity in the hair that evaporates.
• Do not wind the cord around the appliance as this might cause
it to wear prematurely and break. Handle the cord with care
avoiding to bend it or pull it especially when it is plugged in the
socket.
• The appliance is equipped with self-switch-off function after not
being used for 60 minutes. To reactivate the product switch it off
and on again with the operation button (6).
14