Kenwood DNR1008RVS Guia De Inicio Rapido página 36

Connection/Installation
HDMI input
6
Use HDMI cable.
When you connect the cable to HDMI terminal,
remove the fixture. After connecting the cable,
put the fixture again.
W
H
iDatalink connector
7
Dashboard camera interface
8
Connect a Dashboard Camera DRV-N520
(optional accessory). (P.38)
Rear View Camera Input (Audio)/ AV Audio
9
input (ø3.5 mini jack)
(Rear Camera/ AV-IN switchable)
10 Accessory 6: GPS Antenna
Use the supplied GPS antenna. Using the GPS
antenna other than the supplied one may
cause a drop in positioning accuracy.
3rd view camera input (Yellow). See To set up
11
the camera assignment settings (P.39).
Rear view camera input (Yellow)*
12
Front view camera/Dashboard camera input
13
(P.39)
(Yellow).*
2
Video output (Yellow)
14
Video input (Yellow)
15
*1 Connect an HD camera to Rear view camera
input terminal to use HD video.
*2 Connect an HD camera to Front view camera/
Dashboard camera input terminal to use HD
video.
36
Fixture
HDMI connector
W: 20.6 mm or less
H: 10.0 mm or less
D
D: 29.2 mm or less
1
Ñ
Connecting a USB device
Accessory 2 (1 m)
USB terminal
USB maximum power supply current :
[1]
DC 5 V = 1.5 A
Sold separately
[2]
See Securing the USB extension cable
[3]
(P.36).
Ñ
Securing the USB extension
cable
Secure the USB extension cable with insulating
tape or the like so that its connectors are not
disconnected.
[3]
USB device
[2]
[1]