EGO PS1000E Manual De Instrucciones página 15

PROBLEM CAUSE
◾
Chain does not engage drive sprocket.
◾
Insufficient chain tension.
◾
Dull chain.
Motor runs, but
◾
Chain installed backwards.
chain does not
rotate.
◾
Worn chain.
◾
Dry or excessively stretched chain.
◾
Chain not in bar groove.
◾
Chain oil tank is empty.
Bar and chain
running hot and
◾
Debris in guide bar groove.
smoking.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
SOLUTION
◾
Remove the battery pack and reinstall the chain,
making sure that the drive links on the chain are
fully seated on the sprocket.
◾
Loosen the quick chain-tension adjust knob
at least one circle counterclockwise first and
then fully tighten it clockwise until the chain is
correctly tensioned.
◾
Sharpen the chain cutters by a qualified service
technician.
◾
Remove the battery pack and reinstall the saw
chain, following the section "REPLACING THE
BAR AND CHAIN".
◾
Remove the battery pack and replace the chain
following the section "REPLACING THE BAR
AND CHAIN".
◾
Check the oil level. Refill the oil tank if
necessary.
◾
Remove the battery pack and reinstall the saw
chain, following the section "REPLACING THE
BAR AND CHAIN".
◾
Filling bar and chain lubricant.
◾
Clear the debris in the groove.
56 VOLT LITHIUM-ION CORDLESS POLE SAW— PS1000E
EN
15