FIG. 10
10. Install the drawer in the unit. Make sure that the Wooden Knobs (Y) are loose enough to allow
the Drawer Face (G) to move freely on the Drawer False Front (M). Adjust the Drawer Face so
that it is centered side to side and parallel to the top. Tighten the Machine Screws to eliminate
any shifting of the face. Insert four #8x7/8" LoProfi le Screws (ZF) through the holes in the Drawer
False Front and tighten securely.
Hinge
Arm
P
P
FIG. 11
11. With the Doors (F) laying face down on a clean, protected surface, place a Hinge (T) in the large
hole in the back of the door. Line up the screw holes in the Hinge with the predrilled holes in the
door and insert two #6x3/4" P.O. Zinc Screws (P).
Attach the Wooden Knob (Y) to the Door with a #8x1" Machine Screw (W).
PAGE 10 — 273W
T
DOOR
G
ZF
Y
FIG. 10A
W
M
DOOR
FIG. 11A
ZF
Y