Description of the device
Illustration A
Suction pipe
1
Suction hose
2
Carrying handle
3
Filter cover lock
4
Filter cover
5
Rechargeable battery pack
6
Type plate
7
Foot button of semi-automatic brush cleaning
8
Suction hose port
9
HEPA filter (special accessory)
10
Filter bag lock
11
Filter bag
12
Motor protection filter
13
Battery pack release
14
Tread for unlocking the brush head
15
Brush head
16
Brush cover rotary lock
17
Roller brush
18
Brush cover
19
Suction hose at brush head
20
Suction control (variable)
21
Control panel
22
Handle
23
Control lamp
24
Runtime display/error code display
25
Eco button (energy-saving mode)
26
Main switch
27
Preparation
1. Unpack the device and install the accessories.
Illustration B
* only included with the scope of delivery for the
CV 30/2 Bp Adv *INT
Startup
Inserting the battery pack
1. Slide the battery pack into the battery holder and
lock it in place.
Charging the battery pack
Note
Please read the operating instructions of the charger
manufacturer, especially the chapters on safety instruc-
tions!
Note
Please read the operating instructions of the battery
pack manufacturer, especially the chapters on safety in-
structions!
Note
The battery pack is partially charged on delivery.
Charge before use and when necessary.
Note
The battery pack can only be charged when it is re-
moved.
1. Press the unlocking button and remove the battery
pack.
2. Charge the battery pack according to the operating
instructions of the charger manufacturer and the
battery pack manufacturer.
Installing HEPA filter (optional accessory)
1. Unlock and remove the filter cover.
2. Push out and remove the motor protection filter.
Illustration C
3. Slide the HEPA filter (optional accessory) into the
holder, swivel downwards and engage.
Illustration D
4. Insert the filter cover and engage audibly.
Illustration E
Installing the filter bag
1. Unlock and remove the filter cover.
2. Pull the opening of the filter bag over the suction
connection as far as it will go. The locking mecha-
nism of the filter bag engages.
Illustration F
3. Insert the filter cover and engage audibly.
Switch on the device
1. Switch on the device at the main switch.
Eco button (energy-saving mode): The device works
with reduced suction performance. The battery run time
is extended.
1. To activate Eco-mode: Actuate the Eco button.
2. To switch off Eco-mode: Actuate the Eco button re-
peatedly.
Adjusting the suction power
Note
Reduce the suction power at the control dial to reduce
the pushing force on deep-pile carpets.
1. Adjust the suction power (min-max) via the rotary
control.
Roller brush operation
ATTENTION
Device is operated too long on the same spot
Risk of damage to the floor covering
Only operate the device briefly on the same spot.
1. Unlock brush head. While doing so, step on the
tread and swing the handle backwards. The roller
brush is switched on.
2. Perform cleaning.
3. Work interruption/end of cleaning: Lock the brush
head. While doing so, step on the tread and swing
the handle forward. The roller brush is switched off.
Semi-automatic brush cleaning
Note
The semi-automatic brush cleaning should be operated
at least once a day, depending on the application, to re-
move light soiling. For heavier soiling, see "Cleaning the
roller brush manually".
English
Operation
Eco-Mode
11