MSW Motor Technics MSW-AVR 8500F MAX EURO5 Manual De Instrucciones página 45

• Turn the ignition to the "ON" position
Press the starter button to start the engine by holding it down
•
until the engine starts or, in the case of the MSW-AVR DG750
EURO5 model, hold the ignition key in the "START" position
until the engine starts. Normal engine start-up takes only a
few seconds, but in cold conditions it may take a little longer.
NOTE: if the engine does not start after 10 seconds, release
the starter button/key, wait 15 seconds and try to start the
engine again. Trying to crank the engine for too long may
weaken the battery.
• After starting the engine, let it run without load for 3 min.
until it reaches operating temperature.
3.3.4 WORKING WITH A GENERATOR
• (selected models) select the current you want to use with the
switch (230 or 400V)
Connect the current receiving device (or more devices,
•
always starting with the one that consumes the most power)
Set the throttle lever to higher RPM - move it to the "RUN"
•
position.
• Switch on the connected receiver - in the case of more than
one appliance, always start with the strongest one and switch
them on one after the other, also starting with the strongest
one, never all at the same time.
IMPORTANT: Before starting work, check that the generator
is capable of supporting the load of the connected load
equipment. If the generator suddenly shuts down, this means
that the current consumption is too high. You can try to
increase the speed by setting the throttle lever fully in the
"RUN" position - observe the indications of the voltage meter
(5) or the control panel (14).