marklin 59960 Manual De Instrucciones página 10

Note: The display on your mobile device depends on the mobile device in question.
Displays of the indicators in these instructions are samples and are not 100% transferrable to your device.
Settings ex.
WLAN
Functions
Direction
Operation
Control of this working display case is done with a mobile device
as described under „Functions". The display on the mobile device
depends on the options available on it and therefore this cannot
be reproduced here or this can only be shown in an approximate
example.
Control is done with the Internet browser on the mobile device. No
Lighting in
additional App is required.
the display
Control of an Installed Locomotive
case
Requirements:
• The desired locomotive is installed on the display board and has
electrical contact.
• The driven wheels can run free and have no contact with the
track.
• The display case is supplied with power from a switched mode
power pack.
Functions
• A connection is made between the mobile device and the display
case (as described under „Connections").
Calling up the Control
Call up the Internet browser on your mobile device. Enter the
address 192.168.160.1 in the field for the address. After a short time
a window will open, in which you will see square buttons on the left
and right.
Locomotive
If the locomotive has been installed correctly and if electrical
contact has been set up in the display case, the locomotive will
speed
automatically register itself. It will be displayed a short time later on
your mobile device (example in image on page 6).
Now you can run the locomotive using the speed bar displayed in the
center. The locomotive functions can be controlled using the square
buttons on the left and right. Any smoke unit installed in the locomo-
tive may not be activated in the (closed) display case!
Note: When the display case is started again, the Stop function is
active. Press once on
In case of an interruption in voltage to this working display case
(switched mode power pack unplugged), the settings for the working
display case will remain preserved.
General Settings
You can change the settings for this display case by using the gear
symbol in the upper left. Here you can set the language or activa-
10
to turn this function off.