Publicidad
Idiomas disponibles
Idiomas disponibles
2610067395 GKS18V-26L 08-21.qxp_GKS18-25C 8/5/21 12:39 PM Page 13
4.
Slide blade 13 through slot in the foot
10 and mount it against the inner washer
25 on the shaft 26. Be sure the large
diameter of the outer washer 12 lays
flush against the blade (Fig. 2).
5.
Reinstall outer washer and tighten blade
stud 11 finger tight in the direction a.
Press and hold lock button 15 to lock
shaft and TIGHTEN BLADE STUD
COUNTER-CLOCKWISE 1/4 TURN WITH
THE WRENCH PROVIDED (Fig. 2).
Do not use wrenches with longer handles,
since it may lead to over tightening of the
VARI-TORQUE CLUTCH
blade stud.
This clutching action is provided by the
friction of the outer washer 12 against the
blade 13 and permits the blade shaft to turn
when the blade encounters excessive
resistance. When the blade stud 11 is
properly tightened (as described in No. 5 of
Attaching The Blade), the blade will slip when
it encounters ex cessive resistance, thus
reducing saw's tendency to KICKBACK.
One setting may not be sufficient for
cutting all materials. If ex cessive blade
slippage occurs, tighten the blade stud a
fraction of a turn more (less than 1/8 turn).
OVERTIGHTENING THE BLADE STUD
Fig. 3
dUST
BAG
Saw Assembly
NULLIFIES THE EFFECTIVENESS OF THE
CLUTCH.
Dust Extraction
dust port and vacuum hose so that they
do not interfere with the lower guard, or
the cutting operation at all settings.
Materials in fine particle form may be
explosive. Do not throw sawdust on an
open fire. Spontaneous combustion, in
time, may result from the mixture of oil or
water with dust particles.
DUST PORT
The dust port 6 swivels so that dust can be
directed in the desired direction (Fig. 3).
DUST BAG (sold separately)
Using Dust Bag – To attach the empty dust
bag, press-fit its coupler end into the saw's
dust port 6 (Fig. 3).
Cleaning Dust Bag – After the dust bag is
2/3 to 3/4 full, remove it from the saw.
Bring the bag to a proper container and
pull open the zipper located on the bottom
of the bag. Hold the bag by the coupler end
VX120
6
To reduce the risk of
injury, always position
Be extremely careful
when disposing of dust.
BOSCH VH-SERIES
HOSE
35mm HOSE
VAC024
1-1/4" or
1-1/2" HOSE
13
Publicidad
