Publicidad
Idiomas disponibles
Idiomas disponibles
2610067395 GKS18V-26L 08-21.qxp_GKS18-25C 8/5/21 12:39 PM Page 15
reduce the risk of starting the tool accidentally.
Depth Adjustment
one tooth is visible below the work piece.
Excessive blade exposure below the
workpiece could result in personal injury
and/or property damage.
used to change the depth while the saw is
in operation, or for plunge cutting. If
blade adjustment shifts while cutting, it
may cause binding and kickback.
To adjust the cutting depth follow these
instructions (Fig. 4):
A.
Disconnect battery pack 4 from tool.
B.
Loosen the depth adjustment lever 21
located on the right side of the tool.
C.
Hold the foot 10 down with one hand
and raise or lower saw by the handle 3.
-
For a smaller cutting depth, pull the
saw away from the foot 10;
-
for a deeper cutting depth, push the
saw toward the foot 10. The cutting
depth scale 7 has both inch and
metric scales.
D.
Tighten the depth adjustment lever at
the desired depth setting.
Note: Not more than one tooth length of
the blade should extend below the material
to be cut, for minimum splintering (Fig. 5).
Operating Instructions
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
Adjust the cutting depth
so that no more than
The depth adjustment
system should be not
Fig. 4
(10)
(7)
Fig. 5
19
18
Not more than one tooth
length should penetrate wood
for minimum splintering
(4)
(21)
15
Publicidad
