Lavor VULCANO Instrucciones Para El Uso página 18

EN
Press the switch ① to "ON".
Turn the thermostat ② to the desired
temperature setting.
Press the gun trigger.
CARE AND MAINTENANCE
SCHEDULED MAINTENANCE PLAN
Visit website and download the scheduled
maintenance plan.
(fig. F)
IMPORTANT: Before doing any work
on the unit, discharge the pressure and
disconnect the electricity and water
supplies.
• WARNING: Do not spray the appliance
with water and do not use detergents or
aggressive solvents. Machine could be
damaged.
·
Clean the exterior part of the machine with a dry
cloth.
> STORAGE
· Move the machine only by grasping the
carrying handle
· Store the appliance and the accessories in a
dry room.
· Store the appliance and the entire accessories
in a frost-safe room.
CHECKING THE WATER INTAKE FILTER
Inspect and clean the water intake filter on the
intake union periodically. This is important to
prevent fouling which may impair operation of
the pump.
18
CLEANING THE FUEL FILTER
Check the fuel filter periodically and replace if
it has deteriorated or is excessively dirty.
DESCALING
The descaling procedure must be carried out
periodically with specific products. The inter-
val depends on the hardness of the water. Pour
one litre of product for every 15 litres of water
into a drum containing at least 30 litres of wa-
ter. Disconnect the gun from the high pressure
line and place its free end in the drum, in order
to form a closed circuit, and draw the solution
into the machine for at least 10 minutes. The
delivery end of the line should discharge into a
canvas or mesh bag so that the scale removed
is not returned to the circuit. Then restore the
normal connection and rinse with plenty of
cold water. This operation should be carried
out by our after-sales service, since the desca-
ling product may cause wear of components.
Comply with the regulations in force when dis-
posing of the descaling agent.
BOILER CLEANING
( fig. G)
• WARNING: For all maintenance of the
boiler, of the high pressure pump and of
the machine, it is necessary to address to
qualified personnel or to an authorized
assistance center.
The boiler cleaning must be periodically ex-
ecuted every 180 ÷ 200 hours of working pro-
ceeding as follows:
- Carefully remove the nozzle holder flange
and the electrodes holder (boiler head).
- Clean with compressed air the nozzle filter
and check the electrodes position.
- Remove the boiler cap, clean the deflector.
- Manually take away the interior cap.
- Unscrewing the locking nuts and take the
boiler coil out.