Lavor VULCANO Instrucciones Para El Uso página 20

EN
Cause
• The O-ring casing is worn out.
• High moisture in the air.
• The seals are completely worn out.
Repair • Check and/or replace the O-ring.
• Replace the oil with double frequency in
respect of the one suggested.
• Replace the seals.
Filtrations of water from the drains
Fault
between casing and head
Cause • The seals are worn out.
• The piston is worn out.
• The O-ring of the piston cap is worn out.
Repair • Replace the seals.
• Replace the piston.
• Replace the seal.
Fault Filtrations of oil from the drains be-
tween head and casing
Cause • O-ring seals of casing are worn out.
Repair • Replace the seals.
Fault Turning on the burner switch the
boiler does not start
Cause • No fuel.
• Fuel filter is clogged.
• Fuel pump is either blocked or burnt out.
• Damaged thermostat.
• Ignition spark insufficient or totally lacking.
• The space among the electrodes is not
correct.
• Burn out fuse.
Repair • Check the level in the tank and check
whether the rigid suction pipe is clean.
• Replace the line filter.
• Replace it.
• Replace it.
• Contact an authorised service centre.
• Check the positioning.
• Replace it.
Fault Water is not hot enough
Cause • Poor boiler performance.
• Boiler coil clogged with limestone.
Re-
• Clean burner nozzle filter.
pair
• Clean fuel filter.
• Check diesel pump pressure.
• Descaling.
Fault Too much smoke from the chimney
20
Cause • Combustion is not correct.
• Impurities or water in the fuel.
Re-
• Clean fuel filter.
pair
• Clean the boiler.
• Empty the tank and clean it carefully.
• Clean fuel filter as well.
> REPAIRS - SPARE PARTS
For any problems not mentioned in this ma-
nual, or if the machine breaks down, you are
urged to contact an Authorized After-Sales
Service for the relative repair or for any re-
placement of components with original spare
parts. Use exclusively original replacement
parts.
> WARRANTY CONDITIONS
All our machines are subjected to strict tests
and are covered against manufacturing de-
fects in accordance with applicable regulations
(minimum 12 months). The warranty is effecti-
ve from the date of purchase. If your high pres-
sure washer or accessories are handed in for
repair, a copy of the receipt must be enclosed.
Guarantee repairs are being made on the
following conditions: - That defects are at-
tributable to flaws or defects in materials or
workmanship. - That the directions of this in-
struction manual have been thoroughly obser-
ved. - That repair has not been carried out or
attempted by other than authorized service
staff. - That only original accessories have been
applied. - That the product has not been expo-
sed to abuse such as knocks, bumps or frost.
- That only water without any impurities has
been used. - That the high pressure washer has
not been used for rental nor used commercial-
ly in any other way.
The following are not included in the war-
ranty: - Parts subject to normal wear. - The
high-pressure tube and optional accessori-
es. - Accidental damage, caused by transport,