Imetec M2902 Instrucciones De Uso página 13

• DO NOT use the appliance with wet hands,
damp feet or barefoot.
• DO NOT pull the supply cord or the appliance
itself to remove the plug from the socket.
• DO NOT pull or lift the appliance by the supply
cord.
• DO NOT expose the appliance to humidity,
to the effects of weather (rain, sun, etc.) or to
extreme temperatures.
• DO NOT leave the appliance unattended while
it is connected to the power supply.
• Always disconnect the appliance from the mains
supply before cleaning or performing maintenance
and when the appliance is not in use.
• If the appliance is faulty or malfunctions,
switch it off and do not tamper with it. Contact
an authorised technical service centre for any
repairs.
• If the supply cord is damaged it must be replaced
by an authorised technical service centre, so as
to prevent all risks.
• When the appliance is used in a bathroom,
unplug it after use since the proximity of water
presents a hazard even when the appliance is
switched off.
• For additional protection, the installation of a
residual current device (RCD) having a rated residual
operating current not exceeding 30 mA (ideal 10 mA)
is advisable in the electrical circuit supplying the
bathroom. Ask your installer for advice.
WARNING! DO NOT use this appliance near
bathtubs, showers, basins or other vessels
containing water.
• This appliance shall not come into contact
with water, other liquids, sprays, steam. For any
cleaning and maintenance operation refer to the
instructions in the relevant chapter.
11
EN