SYMBOLS THAT APPEAR ON THIS MANUAL
DANGER!
It indicates a dangerous situation with risk of
death for the operator.
WARNING!
It indicates a potential risk of injury for people.
CAUTION!
It indicates a caution or a remark related to
important or useful functions.
Pay careful attention to the paragraphs marked
by this symbol.
NOTE
It indicates a remark related to important or useful
functions.
CONSULTATION
It indicates the necessity to refer to the Instructions
for use Manual before performing any procedure.
GENERAL INSTRUCTIONS
Specific warnings and cautions to inform about potential
damages to people and machine are shown below.
DANGER!
– Before performing any maintenance, repair, cleaning or
replacement procedure disconnect the plug from the
electrical mains.
– Do not wear jewels when working near electrical
components.
– Do not operate the machine near toxic, dangerous,
flammable and/or explosive powders, liquids or
vapours: This machine is not suitable for collecting
dangerous powders.
WARNING!
– This machine must be used by properly trained
operators only.
– Carefully read all the instructions before performing any
maintenance/repair procedure.
– Improper connection can cause electric shock. Connect
the machine to a properly earthed mains supply.
– Do not tamper with the power supply cable plug. If the
power supply cable plug cannot be connected to the
outlet, have an outlet installed by a qualified technician,
according to the law in force.
– Before connecting the power supply plug to the
electrical mains, check that frequency and voltage,
shown on the machine serial number plate, match the
electrical mains voltage.
– Do not unplug the machine by pulling the supply cable.
To unplug, grasp the plug, not the cable.
– Do not handle the plug or the machine with wet hands.
– Turn off all controls before unplugging.
– Regularly check the power supply cable for damages,
cuts, cracks and wear. If necessary, replace it.
– If the power supply cable is damaged, it must be
replaced by the Manufacturer or by an authorised
Service Centre.
– Do not pull or carry the machine by the power supply
11/2015
INSTRUCTIONS FOR USE
cable and never use the power supply cable as a handle.
Do not close a door on the power supply cable, or pull
the power supply cable around sharp edges or corners.
Do not run the machine on the power supply cable.
The rotating brush must not come into contact with the
power supply cable.
– Keep the supply cable away from heated surfaces.
– To reduce the risk of fire, electric shock, or injury, do
not leave the machine unattended when it is plugged
in. Disconnect the machine from the electrical mains
when not in use and before performing maintenance
procedures.
– Not for outdoor use. Always protect the machine against
the sun rays and wet conditions. This machine must be
stored indoor.
– Before using the machine, close all doors and/or covers
as shown in the Instructions for use Manual.
– EU countries: This appliance can be used by children
aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been
given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
– Non-EU countries: This machine is not intended for use
by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and
knowledge.
– Close attention is necessary when used near children.
– Use only as shown in this Manual. Use only Clarke 's
recommended accessories.
– Check the machine carefully before each use, always
check that all the components have been assembled
before use. If the machine is not perfectly assembled it
can cause damages to people and properties.
– Take all necessary precautions to prevent hair, jewels
and loose clothes from being caught by the machine
moving parts.
– Do not use the machine on incline.
– Do not use the machine on slopes with a gradient
exceeding the specification.
– Do not use the machine in particularly dusty areas.
– Use the machine only where a proper lighting is
provided.
– While using this machine, take care not to cause
damage to people or objects.
– Do not bump into shelves or scaffoldings, especially
where there is a risk of falling objects.
– The machine working temperature must be between
32 °F and 104 °F (0 °C and +40 °C).
– The machine storage temperature must be between
32 °F and 104 °F (0 °C and +40 °C).
– The humidity must be between 30 % and 95 %.
– When using floor cleaning detergents, follow the
instructions on the labels of the detergent bottles.
– To handle floor cleaning detergents, wear suitable
gloves and protections.
– Do not allow the brush to operate while the machine is
stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a
water extinguisher.
– Do not tamper with the machine safety guards
and follow the ordinary maintenance instructions
scrupulously.
– Do not allow any object to enter into the openings.
107408647 - MA10 12E
ENGLISH
3