PROZIS Klipper Manual Del Usuario página 5

EN
User manual
PACKAGE CONTENTS
• 1 x Prozis Klipper - Hair Clipper
• 4 x Comb attachment (3/6/9/12 mm)
• 1 x Cleaning brush
• 1 x Charger
• 1 x Oil bottle
• 1 x Quick guide
PRODUCT OVERVIEW (SEE PAGE 2)
1. Clipper blades 2. Cutting length control 3. LED display 4. Guide comb - 12 mm 5.Guide
comb - 9 mm 6. Guide comb - 6 mm 7. Guide comb - 3 mm 8. ON/OFF Switch 9. Charging
socket 10. Cleaning brush 11. Lubricating oil 12. AC/DC adapter
Maintenance and cleaning
• Always clean the blades after use.
• Switch the product off and remove all plugs before cleaning!
• Remove the comb attachment (if fitted). Clean the blades and the comb attachments with a
cleaning brush to remove any remaining hair.
• Do not use aggressive or abrasive cleaning agents or materials such as scouring milk or
steel wool to clean the appliance. They can damage its upper surface!
• Protect the device from water drops and water spray. Use only a clean, dry cloth to clean
the appliance and never use any corrosive liquids. Use a slightly damp cloth and a mild
cleaning agent to remove any stubborn dirt.
• Make sure moisture does not enter the product while cleaning to prevent damage to the
product and related repairs.
Removing the cutting blades
Periodically removing the blade assembly for a more thorough cleaning is advisable.
1. Make sure the appliance is switched off.
2. Use your thumb at the front of the clipper, and press back against the cutting blades. The
blade assembly will snap out of the blade holding base.
3. Clean the blade assembly and inside the blade holding base thoroughly using the clean-
ing brush.
4. Reassemble the blade by engaging the bottom latch, then pressing the top into the blade
holding base. Do not use any harsh detergents, abrasives, solvents or cleaners. Never
immerse in water to clean.
5. Dry thoroughly before use.
Storage
• Allow the appliance to cool down completely before storing it.
• When no longer using the device, store the product in a dry environment, protected from
8
dust and direct sunlight.
• If the appliance is not going to be used for a long period of time, you should recharge it on
a regular basis. This helps maintain battery performance.
• Store your appliance inside the original case provided.
• The cutting blades should be lightly oiled with the oil provided once every few haircuts.
INSTRUCTIONS
Charging:
Before using the charger, make sure the voltage of your electricity supply is the same as the
one indicated on the charger. Your clipper contains a detachable rechargeable battery and
may be used cordless for more than 150 minutes (when the battery is fully charged). When
the clipper is charging, a blue light will flash. When fully charged, the blue light will remain
steady.
NOTE: The battery must be charged for a minimum of 3 hours on its first charging cycle. This
will ensure maximum battery life.
OPERATING INSTRUCTIONS
Fitting a comb attachment:
1. Comb attachments clip on to the blade. They leave a longer length than the blade used on
its own and each one will cut the hair to a different length. The cutting length is marked on
the comb. Comb cut lengths: 3/6/9/12 mm
2. Add a comb attachment by sliding it onto the clipping blade as shown in the picture, until
fully engaged.
Setting the cutting length
To set the cutting length, rotate the cutting length control ring to your desired cutting length
(0,8/1,2/1,6/2,0/2,5 mm). The cutting length is marked on the control ring as shown in the
picture.
EN
9