Procedures For Transporting - Clarke FOCUS S28 Manual Del Operador

PROCEDURES FOR TRANSPORTING

How To Put The Machine In A Van Or Truck
WARNING:
1. Make sure the loading ramp is at least eight (8) feet long, and strong enough to support the machine.
2. Make sure the ramp is clean and dry.
3. Put the ramp in position.
4. Remove squeegee assembly, brush housings, & brushes or pad drivers before loading.
5. Turn key switch "ON".
6. Align the machine on a level surface ten (10) feet in front of the ramp.
7. Put the traverse speed switch in the "HI" position.
8. Press one or both forward switches.
9. Push the machine to the top of the ramp.
10. Turn the key switch "OFF".
11. Fasten the machine to the vehicle.
How To Remove The Machine From A Van Or Truck
1. Make sure there are no obstructions in the area.
2. Make sure the unloading ramp is at least eight (8) feet long and strong enough to support the machine.
3. Make sure the ramp is clean and dry.
4. Put the ramp in position.
5. Unfasten the machine.
WARNING: The machine is heavy. Make sure you use two able persons to assist in
moving the machine down the ramp.
6. Turn the key switch "ON".
7. Carefully and slowly, drive the machine to the top of the ramp by pressing and holding either of the forward
switches and the reverse switch.
8. Put the traverse speed switch to the mid range speed setting. As the machine begins to travel down the
ramp, maintain a slow downward speed by pressing either of the forward switches.
9. Replace squeegee assembly, brush housings, & brushes or pad drivers after the machine is unloaded
and ready to use.
Clarke ®
Operator's Manual - FOCUS S28/L28/S33/L33/S38/L38 WB
The machine is heavy. Make sure you use two able persons to assist
the machine in climbing the ramp.
EN
- 15 -