Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use: The power tool is intended for driving in and
loosening screws as well as for drilling in wood, metal and
plastic.
Inspect the Screwdriver before using to ensure all the parts
are running smoothly and there are no abnormal sounds or
sparks.
WARNING: Before using screwdriver
to drive fasteners into walls, check
behind walls for wire and other electrical
shock hazards or plumbing.
BEFORE OPERATING THIS TOOL
A) CHARGE THE BATTERY
The battery charger supplied is only for the Li-ion battery
installed in the tool. Do not use another battery charger. The
Li-ion battery is protected against deep discharging. When
the battery is empty, the tool is switched off by means of a
protective circuit: The tool will not turn on when the trigger
is engaged. When the Battery is charged for the first time
or after prolonged storage, the Battery Pack will accept
a 100% charge only after several charge and discharge
cycles.
B) CHARGING (See Fig. A)
Plug the charger plug into a suitable power outlet.
Next, connect the charger to the Charging Socket on
the screwdriver; the indicator will illuminate Red during
charging. Let the battery charge for 3-5 hours. The battery
is fully charged as soon as the indicator changes to Green.
Then unplug the charger. Disconnect the Charger from the
screwdriver. The screwdriver is ready to be used.
Important: When charging, the charger and screwdriver
may become warm to the touch; this is normal and does not
indicate a problem.
SELECTING A BIT
Pull the Slide button back (1) completely. Manually rotate
the Bit Cartridge counterclockwise until the desired bit
appears in the top window (2). Push the Slide button
forward (3) completely. (SEE Fig. B1 & B2). The magnetic
chuck will hold the bit firmly in place.
18
NOTE: The Screwdriver will not operate if
the Slide button is not fully pushed into the
forward position.
REPLACING A BIT
If the bits in the Bit Cartridge need to be replaced, remove
Bit Cartridge by pulling the Slide button back and pushing
the Bit cartridge through the left window. Replace the
bits with the desired bits. Ensure the bits are properly
positioned in the Cartridge and are not protruding from the
back of the Bit Cartridge. Or simply pull a worn or broken
bit from the chuck and replace it with a new one. It will load
into the Cartridge automatically when the Slide button is
pulled back. (See Fig. C).
NOTE:
1) Only 25 mm bits are compatible with the screwdriver.
2) If the Slide button is not pulled back fully, the Bit Cartridge
will get stuck when taking it out from the tool. Pull the Slide
button all the way back.
3) The Slide button may not fully push forward if the bit
cartridge is not properly aligned inside. Make sure the bit
cartridge has clicked into place when selecting the desired
bit to use. If the Slide button cannot properly be pushed
forward, just turn the bit cartridge slightly clockwise or
counterclockwise and try again.
FORWARD / REVERSE SWITCH (See Fig. D)
This switch changes the chuck bit rotation direction. Push
the top of the rocker switch for driving reverse and push the
button for removing screws/ forward.
WARNING: Never change the
direction of rotation when the Chuck
is rotating; wait until it has stopped!
USING THE LED LIGHT (SEE FIG. E)
To turn on the light simply press the On/Off Switch. When
you release the On/Off Switch, the light will be off. LED light
increases visibility and is great for dark or enclosed areas.
PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by
the "Discharging Protection System". When the battery is
empty, the tool is switched off by means of a protective
circuit: The chuck no longer rotates. When this occurs you
need to recharge the battery.
EN
Publicidad
