Husqvarna 525iECS Manual De Usuario página 12

3. Fasten the screw (A), then fasten the clamp bolt (B)
firmly, 6-8 Nm / 53-70 in-lb.
a) For model 525iECS:
b) For model 525iES:
B
A
To assemble the cutting attachment
WARNING:
attachment without without an approved
cutting attachment guard. If an incorrect or
faulty cutting attachment guard is fitted this
can cause serious personal injury.
1. Fit the drive disc (A) on the output shaft. Make sure
that the edge of the drive disc, that fits in the hole of
the blade, is facing outwards.
a) For model 525iECS:
C
D
12
A
B
Never use a cutting
E
A
B
b) For model 525iES:
C
D
2. Lock the blade rotation by inserting the locking pin
(E) in the hole on the drive disc.
3. Fit the blade (B) on the drive disc.
4. Fit the support flange (C). The support flange must
be fitted so that its outer edge presses against the
blade.
5. Fit the locknut / blade mounting bolt (D). The
locknut / blade mounting bolt has a left-hand thread.
Tighten the locknut / blade mounting bolt to a torque
of 15-20 Nm / 12-15 ft-lb.
6. Remove the locking pin.
To adjust the cutting depth of the
cutting attachment
The cutting depth of the cutting attachment must be
adjusted before starting work.
1. Loosen the wing nut.
a) For model 525iECS:
A
E
B
1847 - 001 - 28.11.2022