N-Com ESSIII Guía Rápida página 8

WARNINGS AND WARRANTY
WARNINGS AND SAFETY
Product compliant with EU Directive 2014/53/EU (RED). Complete compliance
statement downloadable at www.n-com.it
Read this User Manual carefully, as well as the simple rules listed below.
Failure to comply with these rules may lead to dangerous situations.
Caution: The product cannot be used in official or non-official competitions,
motordromes, circuits, racing tracks and the like.
Caution: Installation of the N-Com system results in a weight increase of
approximately 30g, which is added to the weight of the helmet and of the other
accessories.
Road safety
Always obey all Traffic Regulations in force. While riding your motorcycle, your
hands should always be engaged in actually riding the vehicle. Any operation to
the N-Com system must be carried out with the motorcycle stopped.
Specifically:
• In all cases, obey the Traffic Regulations and remember that riding the
motorcycle has absolute priority over any other manoeuvre.
• The ESS system is equipped with an emergency brake light (ESS – Emergency
Stop Signal). The ESS system IS NOT intended to replace the stop or brake
lights fitted on the motorcycle, consequently its operation alone is not enough
for proper brake signalling.
• Where provided, make sure that the use of the emergency brake light (ESS –
Emergency Stop Signal) is not in conflict with the regulations in force in the
country where you will be travelling.
Switching on the system in safe environments
• Do not turn on the N-Com system whenever their use is forbidden or when
these devices can cause interference or dangerous situations.
• Turn off while refuelling. Do not use the N-Com system at filling stations. Do
not use the device near combustible materials or chemical products.
• Turn off when near explosive materials.
Appropriate use
Use the device only in the normal position, as described in the product
documentation. Do not attempt to disassemble, tamper with, or modify any
part of the N-Com system.
Caution: Incorrect installation of the system in the helmet may alter the
characteristics of the helmet itself, thus creating dangerous conditions. Install
the N-Com system according to the instructions provided in the product
documentation. In case of doubt, please contact your local N-Com dealer.
7