ARDEA ONE CL200x-38 Manual De Instrucciones página 33

16.6 Seat depth extension kit (CLA242-1 / CLA242-2)
N.B. Position the wheelchair on a comfortable surface (workbench).
(FIG.18)
Position the wheelchair on a comfortable surface (workbench).
Remove the screws on the frame, upper (FIG.18) and lower (FIG.19), and on the backrest (rear
sides) (FIG.13) and free the telescopic tubes inside the structure (FIG.20). Move the frame
backwards as far as the new holes in the desired position (2 cm. steps), up to a maximum of 10
cm.
(FIG.21)
Remove the caps from the seat canvas (FIG.21) and remove it by bringing the sides of the
wheelchair slightly closer to each other. Insert the supports of the depth variation kit (4/6 cm.
or 8/10 cm.) into the holes on the rear of the seat frame (FIG.22). Secure the extension tubes
using the specific screws. Reinsert all the frame screws and tighten them completely. Insert the
canvas provided with the kit and slide it from the front of the seat (the storage pocket should
be underneath and at the front). Replace the caps in the four holes. Check that the screws are
tight with the wheelchair open.
N.B. Adjust the sides to the new seat measurement.
16.7 Front wheels (CLA215 - CLA216 - CLA217)
Loosen the screws, remove the wheels, insert the new wheels and tighten after repositioning
at the desired height.
CLA215
CLA215: ø 10 cm unpierceable , PAIR
CLA216: ø 15 cm unpierceable , PAIR
CLA217: ø 17.5 cm pneumatic, PAIR
(FIG.19) (FIG.20)
(FIG.22)
CLA216 CLA217
13