Gloria FINECUT 18V Instrucciones De Uso página 29

RZ_FineCut18V.qxp_Text_GB 06.02.23 19:42 Seite 29
Figures 6 - 7
6
7
- Use the Allen key supplied (3 mm) to
remove both wheels from the wheel
mountings and then mount them in
one of the 2 other wheel mountings.
Make sure that both wheels are
mounted at the same height. The
respective cutting heights are
marked on the mountings.
CAUTION
RISK OF INJURY DUE TO INCORRECT
ASSEMBLY!
Make sure that all parts and screws are
securely tightened so that the device is
in a safe working condition. Do not start
the device until it has been fully assem-
bled!
7 Prior to initial commissioning
WARNING
BEFORE USE OBSERVE CHAPTER 2 "FOR
YOUR SAFETY". You should aslo note
the following safety instructions:

The mains voltage must be in compli-
ance with the voltage specification
(V~) on the type plate of the charger.

Use only the supplied charger with
corresponding original Li-Ion bat-
tery (only item no. 001300.0000).
Operate charger only in dry rooms.
NOTE!

The battery (D) is only partially charged.
Before initial use, fully charge battery.
Please ensure that the charging proce-
dure is performed at room tempera-
ture. This is the only way to ensure a
long battery life.

A significantly decreased runtime in
spite of charging indicates that the bat-
tery is dead and must be replaced.
Use only original Li-Ion batteries, which
you can purchase from manufacturer's
customer service.

Charger and battery can heat up during
charging. This is normal and not a sign
of a technical defect.

The Lithium-Ion battery can be charged
at any time, regardless of charge state.
Premature interruption of charging
does not cause damage to the battery.
A protective circuit on the battery pre-
vents depth discharge of battery.

The battery is equipped with tempera-
ture monitoring that only permits
charging over a temperature range
between 0 °C and 45 °C. This ensures a
long battery life.

Do not press the On/Off switch again if
the FineCut 18V has switched itself off
automatically. The battery can be dam-
aged. Note the details concerning dis-
posal of the battery.
7.1 Charging procedure
Figures 8 - 9
Remove battery (D) from pack-
aging (only item no.
001300.0000).
3
The charging process starts as soon as
the plug has been plugged into the
power outlet and the battery (D) has
been placed in the charger (M).
Due to the intelligent charging method,
the charging condition of the battery is
automatically detected and the battery is
charged with the optimum charging cur-
rent, depending on battery temperature
and voltage. This gives longer life to the
battery and always leaves it fully charged
when kept in the charger for storage.
Indicator statuses:
The charging process is indicated
by the flashing of the battery charge indi-
cator.
A solid light on the battery charge
indicator signals that the battery is fully
charged or that the temperature of the
battery is not within the permitted charg-
ing temperature range, and can therefore
not be charged. The battery is charged as
soon as the allowable charging tempera-
ture range is reached. When the battery is
not inserted, a solid light on the battery
charge indicator signals that the mains
plug is inserted in the plug socket and
that the charger is ready for operation.
29