RZ_FineCut18V.qxp_Text_GB 06.02.23 19:42 Seite 32
22
Before inserting the new blade set, check
the correct position of the upper blades.
The upper blades need to be positioned
centrally and pointing straight forward as
shown. You may need to align the cams of
the upper blades as shown in the figure.
(
= correct /
23
Now attach the new blade set. The central
large stud and the 3 indicated shafts of
the cog wheels, which need to sit in the
openings of the blade set, can be used as
a positioning aid.
24
Fix the blade set by screwing it at the
position indicated.
25
Replace the base cover on the device
as shown.
26
Then use the 7 screws indicated to
screw the base cover in place.
Lubricate the new blade with machine oil
or lubricating oil spray before using.
The blade set has now been replaced.
9.2 Cleaning
ATTENTION
Improper use of the device poses a risk
of damage to property! You should
therefore observe the following safety
instruction:
Remove the battery each time
before cleaning the device.
Do not immerse the device in water
or spray or clean it with water.
The device must be protected
against moisture.
Clean the outside of the device with
a damp cloth or soft brush. Do not
use abrasives or harsh cleaning
agents.
Dismantle the grass trimmer for a
thorough clean if it is seriously dirty.
Use a brush to clean the cutting unit,
the housing and the two seals, then
oil the blades (J).
Only use original GLORIA spare parts
for repairs.
Further accessories can be found at
https://shop.gloria-garten.com/de/.
= incorrect).
32
10
Decommissioning & Storage
10.1 Decommissioning
Take the device out of operation by releas-
ing the On/Off switch (E) in the handle.
10.1.1 Removing the rechargeable
battery
Figure 27
ATTENTION
Improper use of the device poses a risk
of damage to property! You should
therefore observe the following safety
instruction:
27
To prevent battery discharge, remove
the battery from the device when not in
use for a prolonged time.
10.2 Storage
Figures 28-29
CAUTION
You may be exposed to hazards that could
injure you when handling the device.
You must therefore store the device
away from children.
Remove any dirt and debris.
28
Slide the blade guard (K) onto the
blades (J).
29
Store the device hung up, dry and pro-
tected from frost.
10.2.1 Correct battery and charger
storage
It is essential that you also follow the
"Safety instructions for handling
charger and battery" in chapter
"Important safety instructions".
ATTENTION
Improper use of the device poses a risk
of damage to property. The battery
should not be stored uncharged. Though
self discharge is minimal, an empty bat-
tery can be destroyed if stored for an
extended period. Thus, observe the fol-
lowing instructions if not in use for an
extended period (e.g. during winter):
store battery at a charge status of
approx. 40 - 60 %.