Publicidad
Idiomas disponibles
Idiomas disponibles
Stroller Assembly
UNPACKING THE STROLLER
WARNING!
Remove all packaging
materials and discard
to avoid choking and
suffocation hazards.
STROLLER WHEELS
REAR WHEEL INSTALLATION
1.
Unlock Parking Brake
Prior to installing the rear wheels,
position the parking brake in the
unlocked position.
2. Insert Rear Wheel Stub Axle
Insert the rear wheel's stub axle into
the hole in the rear dropout while
pressing the button until a "click" is
heard. Repeat for other side.
NOTE: If no click is heard, the wheel
may not be secure in the attachment
bracket and may detach during
operation. Pull on wheel to ensure
proper installation.
6
REAR WHEEL REMOVAL
1.
Unlock Parking Brake
Before removing the rear wheels,
position the parking brake in the
unlocked position.
2. Remove Wheel
Raise the wheel a few inches off
the ground, (A) push the release
button, and (B) pull the wheel
out of the rear wheel attachment
bracket. Repeat for the other side.
Release
Button
FRONT WHEEL INSTALLATION
1.
Remove Through Axle
From Front Wheel
Unscrew the tension adjusting nut
from the through axle from the
front wheel.
Tension Adjusting Nut
2. Lock Front Fork
Rotate the front fork until it locks.
See page 5.
3. Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with holes in the fork blades.
4. Insert Through Axle
Insert the through axle into the
fork and through the wheel hub,
then install the tension adjusting
nut to the opposite side.
5. Tighten Tension Adjusting Nut
Tighten the tension adjusting nut
until secure using the hex key.
Tension Adjusting Nut
FRONT WHEEL REMOVAL
1.
Remove Through Axle
Loosen the tension adjusting nut
using the hex key and remove the
through axle from the front wheel
and fork.
2. Remove Front Wheel
Pull the front wheel out of the fork
assembly.
STROLLER CANOPY
CANOPY INSTALLATION
1.
Connect Canopy to
Stroller Frame
Lower canopy connectors onto the
stroller frame mount, then push to
connect.
7
Publicidad
