Descargar Imprimir esta página

STAMOS TRON 200 ONE Manual De Instrucciones página 25

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 93
1.
Welding voltage display.
2.
Welding/cutting current display.
LEDs: "Pre flow" (gas flow time before welding); "Current"; "Post flow" (gas flow time
3.
after welding)
Menu button:
In the MIG mode without pulse choosing the wire feed speed (current), precise
voltage regulation, inductance;
In the MIG pulse mode choosing the wire feed speed (current), precise voltage
4.
regulation, inductance, precise adjustment of pulse frequency, precise adjustment of
pulse work cycle;
In TIG / CUT mode selection of pre-gas, welding current and gas adjustment after
welding/cutting.
Pressing and holding the button for about 3 seconds will return it to default settings.
5.
Synergy mode on/off button in MIG welding.
6.
Control knob - parameter setting in accordance with point 4 above.
Selecting the type of welding wire for MIG welding:
7.
Wire φ 0.8 / 1.0 for stainless steel/carbon steel; φ 1.0 / 1.2 for Al-Si/Al-Mg/Cu-Si.
Voltage adjustment knob: in non-synergy mode, rotate the knob to adjust the voltage
8.
directly.
In synergy mode, turn the knob to get a precise adjustment of +/ -30%.
Material selection in MIG welding:
"Carbon steel" - carbon steel
"Stainless steel" - stainless steel
9.
"Al-Si" - an alloy of aluminum and silicon (the control diode is on all the time)
"Al-Mg" - an alloy of aluminum and magnesium (the LED flashes)
"CuSi" - an alloy of copper and silicon
Selecting the welding/cutting mode: MIG / MMA / TIG / CUT. Pressing and holding the
10.
button will save the data in memory.
PULSE mode selection in MIG welding: "No Pulse" - welding without pulse, "Pulse" -
11.
welding with pulse.
Welding function selection:
2T / 4T for MIG / TIG / CUT:
o 2T - pressing the button on the welding torch initiates the process of
o 4T - pressing the button on the welding torch initiates the process of
12.
VRD for MMA (turning off the VRD function may increase the risk of electric
shock)
welding/cutting the metal and releasing the button ends the process.
welding/cutting the metal, releasing the button does not end the
process. Pressing and releasing the button again completes the
welding/cutting process.

Publicidad

loading