Schwaiger CALED 200 Manual De Instrucciones página 16

USER GUIDE
Tighten
the screw
Install
Open
Securing with
pegs
Step 4
Mount the main unit with the inserted vibration springs on
the mounting clamp for the tripod.
For this purpose, screw the 3 union nuts on the threads
of the mounting clamp.
Step 5
Open the lock of the mounting clamp and put the main
light unit on the tripod.
Then close the clamp again.
Make sure that the lamp is securely seated on the tripod.
Step 6
Now that the lamp is assembled / mounted, it should be
provided with additional support.
To ensure a secure stand even in windy conditions, either
anchor the support feet to the ground or attach an addi-
tional weight to the hook on the middle unit.
For anchoring to the ground you can use the supplied
mounting pegs.
Hook for
adding a
weight
Ensure stable positioning during installation, otherwise
there is a risk of tipping over! Do not use the product as
a coat stand! Do not use it if it is not stably installed!
5.
This lamp has an integrated lithium-Ion battery, which is
charged either via Micro USB or the solar panel on the top
of the product. The lighting units located at the bottom of
the product have been designed so that power is supplied
via charging contacts from the main unit. Therefore, the
solar panel supplies power to all attached units including
itself when lighting conditions are good.
The battery is supplied partially precharged, and should
be fully charged before being used for the first time. The
charging time is approx. 6 1/2 hours.
16
IMPORTANT:
WARNING!
CHARGING/OPERATING THE LAMP
NOTE