Schwaiger CALED 200 Manual De Instrucciones página 17

5.1. Charging via Micro USB
Use the supplied Mirco USB cable to charge the main unit. You will also need a suitable charging adapter with
at least 2 A output power.
To connect the Micro USB cable, open the rubber protection cap on the side and plug in the cable.
IMPORTANT!
During the charging process, make sure that the LED indicator next to the Micro USB connector lights up and
the slide switch is set to "Li-Ion"! If the slide switch is set to "3D", the integrated battery will not be charged!
Meaning of "Li-Ion" & "3D"
This marking indicates the two operating modes of the lamp. With "Li-Ion" the light is powered by the integrat-
ed rechargeable battery, while with "3D" power is supplied by the three C (LR14) batteries.
Explanation of the LED codes
The light has a status LED (combination of a red and a green LED), which indicates the charge level of the
battery.
Explanation of the LED codes
During operation
Charge level
0% - 25 %
25% - 50%
50% - 75%
75% - 100%
5.2. Power supply selection
As already described in the previous section, the lamp can be operated using both the integrated rechargeable
battery and non-integrated batteries. The non-integrated batteries should only be used as an emergency power
source.
The power supply can be selected by means of a slide switch (next to the Micro USB connector) behind the
rubber cover.
In non-integrated battery mode, please insert 3x C (LR14) batteries.
To do so, unscrew the two screws on the bottom of the product by hand and open the battery compartment.
Insert the appropriate batteries and close the battery compartment.
NOTE
We advise you not to operate the lamp exclusively via the non-integrated batteries! Lighting duration is sig-
nificantly reduced in this mode! Also be aware that mobile devices can also be charged via the USB port in
non-integrated battery mode. This shortens the service life / lighting duration even more.
IMPORTANT! SOLAR PANEL
Charging the battery via the solar panel works only if the slide switch is set to "Li-Ion"! The solar panel is
deactivated when "3D" is selected.
LED code
Flashing red
Glowing red
Glowing yellow
Glowing green
During charging
Charge level
0% - 25 %
25% - 50%
50% - 75%
75% - 100%
17
USER GUIDE
LED code
Flashing red
Flashing yellow
Flashing green
Glowing green