Fronius Symo 10.0-3 208-240 Manual De Instrucciones página 33

DATCOM Check the data communication, entry of the inverter number, protocol settings
Setting range
Status
Displays data communication available via Fronius Solar Net or an error that
occurred in data communication
Inverter Number
Number setting (address) of the inverter in a setup with multiple inverters
Setting range
Factory setting
IMPORTANT! Each inverter must be assigned its own address when using mul-
tiple inverters in a data communications system.
Protocol Type
Defines the communication protocol used to transmit data:
Setting range
Factory setting
* The interface protocol type only functions without a Fronius Datamanager
card. Existing Fronius Datamanager cards must be removed from the inverter.
USB Performing firmware updates or saving inverter detail values on a USB thumb
drive
Setting range
Safely remove hardware
To remove a USB thumb drive from the USB A socket on the data communica-
tion rack without losing data.
The USB thumb drive can be removed:
-
-
Software update
For updating inverter firmware using a USB thumb drive.
WLAN Access Point
[not available]
Is displayed if no system monitoring is available on the
inverter.
Status/inverter number/protocol type
00 - 99 (00 = inverter address 100)
01
Fronius Solar Net / Interface *
Fronius Solar Net
Safely remove hardware / software update / logging in-
terval
When OK is displayed
When the "Data Transfer" LED is no longer flashing or lit
33