HSM SECURIO P36i Instrucciones De Servicio página 20

english
8 Other functions and settings
Key lock
You can prevent unauthorised use of the shred-
der by locking the touch-screen display as fol-
lows:
• Press and hold the screen lock button
one second.
 The numeric keypad is displayed.
• Enter a 4-digit number of your choice.
 The display is dimmed. The screen is locked.
Unlocking the screen lock:
• Press anywhere on the display.
 The numeric keypad is displayed.
• Enter the 4-digit number you used to lock the
screen.
 The screen lock is unlocked.
Note
If you have forgotten the numeric code you used
to lock the screen, you can override the screen
lock by entering the master code:
8731
Other function modes
• Permanent mode
Function: Cutting unit runs continuously.
If no material is fed in within a period of
30 minutes, the cutting unit shuts down and
the shredder switches to standby. If fault or
warning messages are displayed, the cutting
unit is also switched off .
Start: Press and hold the centre of the display
panel for 3 seconds.
Premature cancellation: Press the display panel.
• standby conditions
Function: 2 minutes after paper was last fed
into the shredder, the appliance switches to
standby conditions. The shredder starts auto-
matically when paper is fed in.
• standby mode
Function: If the document shredder has not
been used for 10 minutes, the power
consumption is reduced to 0.1 W.
20
• Automatic shutdown
Function: If the shredder has not been used
for 8 hours, the power consumption is further
reduced.
• EcoSmart mode
The document shredder can be operated in
the energy-saving EcoSmart mode.
for
- Set the controller to "On", then the standby
time is 10 minutes.
- Set the controller to "Off ", then the standby
time is 8 hours.
(If the EcoSmart mode is "Off ", you will have
a reduced charging time)
Notes
Manual reversing
If you press the "R" button, the cutting unit runs in
reverse and switches off after 2 seconds, even if
you keep the button pressed. To be able to manu-
ally start another reversing operation, you have
to release the button and press it again. If the
shredder is already running in shredding direc-
tion, pressing this button causes the shredder to
immediately reverse.
Shredded material container
Both cutting units stop when the paper or CD
container is full. On machines with a separate
CD cutting unit, the level in the CD container
(see overview, item 7) is monitored. Empty the
bin after an error message. Please consider the
environment and dispose of the diff erent types of
waste separately.
Automatic oiler (cross cut only)
The cutting unit is regularly lubricated by the inter-
nal oiler.
The "Oil reservoir empty" signal is automatically
deactivated after the reservoir is fi lled. The shred-
der remains operational even when the oil reser-
voir is empty.
Metal detection (optional)
The document shredder can be optionally
equipped with a metal detector. The automatic
switch-off allows damage to the cutting unit by
paper clips or other metal objects to be avoided.
Safety element monitoring
Movement of the safety element was detected
during the shredding procedure. If your machine
switches off without signalling an error, pull the
paper out of the paper slit and feed it back in
again.
HSM SECURIO P36i
07/2022